How to troubleshoot redo queue build up in AlwaysOn?

How to troubleshoot redo queue build up in AlwaysOn?

Troubleshooting REDO queue build-up (data latency issues) on AlwaysOn Readable Secondary Replicas using the WAIT_IN… Jan 15 2019 04:23 PM You have confirmed excessive build up of REDO queue on an AlwaysOn Availability Group secondary replica by one of the following methods:

How to add aggregation in redo queue build up?

The details now appear as columns in the table of events: Click the Grouping button to begin grouping the events – first by session_id and then by wait_type: Then after grouping by session_id and wait_type, you can add Aggregation. Click the Aggregation button:

How to troubleshoot data latency in redo queue?

Click the Aggregation button: Add SUM for both duration and signal_duration and sort the aggregation by duration (SUM) in descending order. The resulting output shows the wait_types (with count of events in parentheses) and the aggregated sum of duration and signal duration – ordered by the highest wait_type duration in descending order:

How long does it take for a redo queue to run?

The time (in milliseconds) between the thread being signaled that the wait condition is over and the time the thread actually resumes executing. In other words, the time the thread spent on the scheduler’s “runnable” list waiting to get on the CPU and run again. How can I use it?

How is lag measured in availability group synchronization?

This is an area that we need to monitor, particularly if the secondary replica is underpowered when compared to the primary replica. Dividing the redo_queue by the redo_rate will indicate your lag. Everything discussed thus far has revolved around recovery in asynchronous commit mode.

What’s the difference between asynchronous and synchronous availability?

Availability modes. There are two availability modes, synchronous commit and asynchronous commit. Selecting a mode is equivalent to selecting whether you want to favor data protection or transaction performance. Both availability modes follow the same work flow, with one small yet critical difference.

When does the wait _ info xevent log in SQL Server?

The WAIT_INFO XEvent logs when a non-preemptive worker thread in SQL Server enters or leaves a “wait state”. (note: pre-emptive threads have their own event: WAIT_INFO_EXTERNAL).

How big is the e-db1 log send queue?

Last week we saw an increasing log_send_queue_size, and a decreasing log_send_rate. This started on the Monday, and carried on through to Friday night, when it was manually resolved (see Fix section below) . At its lowest, the log_send_rate of the E-DB1 database was just over 100KB/sec with a log_send_queue of over 40GB.

Why is the recovery queue counter high in perfmon?

You have observed a high value for the recovery queue counter in the Perfmon SQLServer:Database Replica object . You may also observe some of the following symptoms: Excessive transaction log file growth on all replicas (primary & secondary)

How are availability logs captured in SQL Server?

Logs for each database is captured and sent to the corresponding partner queue (one per database-replica pair). This capture process runs continuously as long as the availability replica is connected and data movement is not suspended for any reason, and the database-replica pair is shown to be either Synchronizing or Synchronized.