Contents
Why is my Ender 3 Pro not extruding?
A commonly reported issue is filament chewing through the arm of the extruder. Users have also experienced the extruder cracking up over time, resulting in a loss of spring tension. The gear can’t grip the filament properly, which leads to extrusion issues.
How much space should be between nozzle and bed?
Your 3D printer nozzle should be from 0.06 – 0.2mm from your printer bed to give it enough space to comfortably extrude material, which is about the width of a piece of paper. This distance also does depend on your nozzle diameter and layer height.
Why does my Ender 3 Pro keep clogging?
If the temperature of your hot end is too low, your print material will not melt correctly. This can cause the material to begin to adhere to the inside surface of the nozzle. Eventually, the extrusion motor can’t feed the filament into the head and before you know it your 3D printer nozzle is clogged.
How hot can ender 3 Pro print?
Hot end: Creality Ender-3 3d printer has a reliable hot-end which easily reach up to 280°C. However, as it is not an all-metal hot-end, so the temperature is limited to 240°C because of the use of PTFE tubing and the quality of the components it’s made of.
Why does the Ender 3 stop off the bed?
I just received my new Creality Ender 3. I was going through and checking/adjusting everything for alignment, and I noticed that when you “auto home” the print head, the nozzle stops off the front of the print bed by 5-10 mm. Is that normal? Is it perhaps by design to allow purging the nozzle without dumping on the bed?
Are there any problems with the Ender 3 Pro?
I run quite a few Ender 3 Pro’s using the same slicer settings (Simplify3D), and just recently I have noticed a very odd extrusion problem. I find that at about the same height on several printers the printer under extrudes by quite a margin.
What’s the build plate on Ender 3 Pro bed?
I print with the hot-end heated at 200 deg, and build plate at 60 deg. The dog and cat prints that came with the memory card were even programmed to print with the bed at 45 deg and even that stuck well. Any ideas? The wide skirt lines in the front and the narrow skirt in the back seem to indicate that the front is higher than the back.
Where is the home position on the Ender 3?
I got myself the Ender 3. The Home position is about 1mm left and 2mm in front of the front left corner. Now, the hotend center axis is 11mm from the carrier plate with the “Mk 10” cooler mounted right onto a pair of 5mm pegs that are part of the plate.