Contents
Where are the SPI pins on an Arduino?
The MCP4131 is basically a resistor network with potentiometer pin outs. We can digitally control the output resistance at pin 6 by sending commands over SPI to pins 1, 2, and 3. Below is a pin diagram for the MCP4131: You might be wondering where the MOSI, MISO, and SCLK pins are.
Where are the serial pins on the Arduino Uno?
SCK (Serial Clock) – A clock signal generated by the Master device to synchronize data transmission. I2C – SCL/SDA pins are the dedicated pins for I2C communication. On the Arduino Uno they are found on Analog pins A4 and A5.
What is the serial clock on an Arduino?
Serial Clock (SCLK) – the line that carries the clock pulse generated by the master device Slave Select/Chip Select (SS/CS) – the connection used by the master device to inform the slave device that it will send or request data. The SS/CS pin should be set to LOW to inform the slave that the master will send or request data.
Where are the SS / CS and SCLK pins on an Arduino?
The SS/CS, MOSI, MISO, and SCLK pins are shown in the diagram below: Pins 10-13 are usually used, but there are also MOSI, MISO, and SCLK pins on the ICSP header (near the ATMEGA chip). The MOSI, MISO, and SCLK on pins 11-13 and on the ICSP header are one and the same, so using the ICSP header doesn’t free up pins 11-13 for other purposes.
How to set clock divider on Arduino SPI?
SPI.begin () − Initializes the SPI bus by setting SCK, MOSI, and SS to outputs, pulling SCK and MOSI low, and SS high. SPI.setClockDivider (divider) − To set the SPI clock divider relative to the system clock. On AVR based boards, the dividers available are 2, 4, 8, 16, 32, 64 or 128.
How does SPI communication between master and slave Arduino?
The above statement sets MISO as OUTPUT (Have to Send data to Master IN). So data is sent via MISO of Slave Arduino. Then turn ON interrupt for SPI communication. If a data is received from master the Interrupt Routine is called and the received value is taken from SPDR (SPI data Register)
How does the Arduino work with the ds1803?
The arduino counts the pulses of a rotary encoder and place the value in variable pot [0] and pot [1]. When you push the switch on the encoder, you can switch between pot [0] and pot [1]. The actual value of the pots are read back from the DS1803 and placed in variable potValue [0] and potValue [1] and displayed on a LCD.
What does SS / CS mean on Arduino circuit?
Slave Select/Chip Select (SS/CS) – the connection used by the master device to inform the slave device that it will send or request data. The SS/CS pin should be set to LOW to inform the slave that the master will send or request data. Otherwise, it is always HIGH