How to resolve clip warning 000117 empty output generated?
However the clip still returns the same error. The large dataset I am trying to clip is the MAMMALS file located at this link (the amphibians and reptiles files work just fine, but the Mammals does not): http://www.iucnredlist.org/technical-documents/spatial-data
Why did I clip all of the polygons?
All the sections except one clipped without any errors, so I zoomed in and found this: Apparently, the file I was given was drawn in a way that it created an overlap between the start and end points that was preventing the clip. After deleting one of the points, the clip for the entire Polygon A ran just fine.
Are there any issues with C-H polygons?
Polygons C-H clip just fine without any errors, so it is usually polygon B that has the issue; however, most of the time there are no issues whatsoever. The polygons do overlap each other. I have repaired the geometry, but the results are the same.
Why is my polygon running after deleting a point?
Apparently, the file I was given was drawn in a way that it created an overlap between the start and end points that was preventing the clip. After deleting one of the points, the clip for the entire Polygon A ran just fine. So, if none of the other solutions work out, it could possibly be a polygon drawn incorrectly.
What is the error ” warning empty output generated “?
Error : 000117: Warning empty output generated. The user is attempting to buffer multiple points in a point feature class. The input and output data are set to Universal Naming Convention (UNC) paths stored on a network drive.
How to solve warning000117-geonet, the ESRI community?
WARNING 000117: Warning empty output generated. Executed (Buffer) successfully. If that was the error message, perhaps you were doing a negative buffer and it was too large a value resulting in null geometry…which is what your output suggests. If that wasn’t it, then you need to provide details.
How to fix the error in ArcMap 000117?
Restart the computer, and start a new project in ArcMap. Add only the layer to be buffered, and run the Buffer tool. Select Environments… In the Environments Settings, set the extent to that of the layer. ArcMap: 000117 : Warning empty output generated.