Contents
What are the setups for the Vector driver?
The following setups are contained: CANcardXL 8.7.16 USB Dongle 7.81.0 Vector Hardware Config 20.30.18 NEW Vector Keyman 11.6.10 Vector Platform Manager 4.0.62 NEW
How is a driver replacement map file created?
Driver Replacement Map File Format. Each driver file replacement is indicated by three lines in the driver replacement map file. The first line consists of the word “map”. The second line specifies the path and file name of the old driver on the target computer. The third line specifies the full path of the new driver.
What happens when a driver file is mapped?
Whenever the target computer is about to load a driver, it queries the kernel debugger to determine whether this driver has been mapped. If the driver has been mapped, the replacement file is sent over the kernel connection and copied over the old driver file. The new driver is then loaded.
Where do I send my support request to vector?
You can submit your support request in the Vector Customer Portal, via e-mail or telephone or use one of the forms below. Please select your issue type below to submit your issue to the Vector support team. Do you have technical questions and need helpful answers?
Can a single variable frequency drive control multiple motors?
A single variable frequency drive (VFD) may control 2 or 3 motors at a time, multiple motors control is usually done because of budget considerations. When in this example below, a cooling tower with 4 equally sized motors are controlled by one variable frequency drive. Motors are to have the same capacity and operate at the same speed.
How are multiple drivers resolved in Stack Overflow?
The full definition of how the multiple drivers are resolved is defined in the ieee.std_logic_1164 package and covers all possibilities, such as a 1 and an L driving etc. The IEEE get shirty about copyright, so I’m not going to post even an excerpt here, but you’ll be able to find it in the source libraries of your simulator.
Can you drive a std _ logic signal from more than one process?
Hope that helps. If you drive a std_logic signal from more than one process (and remember that a continuous assignment outside of a process also creates an implied process!) then all but one of them must be driving Z onto the signal.