Contents
Why is my floor scrubber leaving streaks?
The floor scrubber is leaving streaks because the squeegee has something, usually hair or dust, stuck between the squeegee and the floor. Correct this by dust mopping/sweeping before using the autoscrubber. Your floor scrubber leaving streaks is not totally avoidable.
What are some of the hazards and issues to watch out for when using a side to side floor scrubber and how can you avoid them?
1. Problem: Poor Water Pick Up
- Possible Cause: Damaged or Worn Squeegee Blades.
- Possible Cause: Recovery Tank Is Full.
- Possible Cause: Vacuum System.
- Possible Cause: Full Debris Tray.
- Possible Cause: Pad or Brush.
- Possible Cause: Wrong Pad Pressure Settings.
- Possible Cause: Improper Chemical Usage.
How long does it take to charge a floor scrubber?
Your goal is to fully charge your Floor Scrubber batteries after each use. Preferably, get them fully charged and in float at least 4 hours before use. This is the cooling period in the cycle. It is important to let the batteries cool before they are discharged again.
How long do floor scrubber batteries last?
between two and five years
Simple reasons floor scrubbers fail involve the batteries themselves. For most machines, their batteries should last between two and five years. The lifespan depends on usage frequency and maintenance. To check if your battery is dead, place a voltmeter on the contacts.
What’s a scrubber battery?
Scrubber and Sweeper Batteries Rather than putting up with short running times and constant recharges, a sweeper or floor scrubber battery replacement will keep your commercial floor cleaning machines up and running at full capacity.
How long do large batteries last?
Typically, a car battery will last from three to five years. That said, if your battery is nearing three years old or older, you should consider having it tested. Batteries today are designed to perform at a full charge up until they fail.
What is top scrubbing?
The goal of scrubbing is to remove any embedded dirt and soil from the floors without having to strip. Scrubbing will remove the couple of coats of wax that dirt has embedded into. Scrubbing is also known as deep scrubbing or top scrubbing. This maintenance will help prolong the need for floor stripping.
What to do if your floor scrubber is not working?
It is frustrating when a scrubber is not working and a job needs to be done. As with any type of equipment, they do require some maintenance to continue working properly. Many problems can be avoided just by having the operator become somewhat familiar with the basic functions of the machine and the common issues that may arise.
Why does my power scrub not pick up water?
The Power Scrub will not pick up water even though the power is on. If the water tank is full, you’ll hear a change in pitch and the yellow disk inside the tank will shoot to the top which means the cleaner will not pick up anymore water. You will have to remove the tank and dump out the water before continuing use.
Can a scrubber run at a high level?
An automatic scrubber may be able to perform at a high level but this all requires power. If your scrubber is being expected to scrub ramps, with maximum down pressure, and maximum water flow, the amp draw will be significantly higher than normal. This reduces running time.
Why does my floor scrubber not run when the tank is full?
They also have ping pong balls to block the water from getting into the vac motor. When the recovery tank gets full these balls float up and block the water from getting into the vac motor. The vac motor will still run but there will be no suction. Sometimes these balls can get stuck blocking the air even when the tank is not full.