Contents
How to configure the default gateway in Juniper?
Configuring the Default Gateway. The default gateway is typically set up during commissioning. Note: The default gateway, the shared management IP address, and the individual management IP addresses must all reside on the same subnet. Note: Changing the default gateway will affect the routing of packets.
What are uplink ports for Juniper EX2200 switches?
Uplink ports for the EX2200 switches except the EX2200-C models will be listed as ge-0/1/0 to ge-0/1/3 and for the EX2200-C switches as ge-0/1/0 to ge-0/1/1. There are two ways to connect and configure an EX Series switch: one method is through the console by using the CLI and the other is by using the J-Web interface.
What kind of juniper network switches are used?
Two Juniper Networks SRX5800 Services Gateways with identical hardware configurations running Junos OS Release 9.6 or later. Two Juniper Networks EX8208 Ethernet Switches running Junos OS Release 9.6 or later. Any EX Series switch can be used here.
How to configure Juniper Networks shared management IP address?
Contact Juniper Support Use this procedure to configure the default gateway on the BTI7800. The shared management IP address (and subnet) must be set up. The default gateway is typically set up during commissioning.
How to set switch EX2200 as default gateway?
I have one simple question, but I not know how do it. So, i have switch EX2200 as access switch in network, by cisco have command ip default-gateway . Do have juniper analouges command or i must use set routins-options default ?
When do I set up the default gateway?
The default gateway is typically set up during commissioning. Note: The default gateway, the shared management IP address, and the individual management IP addresses must all reside on the same subnet. Note: Changing the default gateway will affect the routing of packets.