Contents
Why is the purpose setting 2 HSRP standby groups?
Multiple HSRP groups enable redundancy and load-sharing within networks and allow redundant devices to be more fully utilized. A device actively forwarding traffic for one HSRP group can be in standby or in the listen state for another group.
What is the multicast and port number used for HSRP version 2?
224.0.0.102
HSRP version 2 uses the new IP multicast address 224.0. 0.102 to send hello packets instead of the multicast address of 224.0.
What is the difference between HSRP version 1 and 2?
Version 1 is the default version of HSRP. HSRP version 2 uses the new IP multicast address 224.0. This new multicast address allows CGMP leave processing to be enabled at the same time as HSRP. HSRP version 2 permits an expanded group number range, 0 to 4095, and consequently uses a new MAC address range 0000.0C9F.
Which behavior can be expected when the HSRP versions is changed from 1 to 2?
Which behavior can be expected when the HSRP version is changed from 1 to 2? A. No changes occur because the standby router is upgraded before the active router.
How do I enable HSRP?
To achieve basic HSRP configuration, you need to do the following:
- Configure normal IP address on interface (cannot be the same as HSRP virtual IP)
- Bring interface up (no shutdown)
- Configure HSRP group and virtual IP address using the standby command.
What is interface tracking in HSRP?
Interface tracking allows you to specify another interface on the router for the HSRP process to monitor in order to alter the HSRP priority for a given group.
How to use HSRP version 2 in Windows 10?
not present Command or Action Purpose Step 5 standbyversion{1| 2} Example: ChangestheHSRPversion. Step 5 ChangestheHSRPversion. Device(config-if)# standby version 2 Step 6 standby[group-number]ip[ip-address[secon ActivatesHSRP. Thegroupnumberrangefor .
What’s the MAC address range for HSRP version 2?
HSRP version 2 permits an expanded group number range, 0 to 4095, and consequently uses a new MAC address range 0000.0C9F.F000 to 0000.0C9F.FFFF. The increased group number range does not imply that an interface can, or should, support that many HSRP groups.
How many operational groups do HSRP timers use?
In the case of HSRP, a given device may have up to 4000 operational groups configured. In order to distribute the load on the device and network, the HSRP timers use a jitter. A given timer instance may take up to 20% more than the configured value.
Which is HSRP router requires that I preempt?
However, the Cisco 2600 and Cisco 3600 do support multiple MAC addresses on all Ethernet and Fast Ethernet interfaces. Q. Which HSRP router requires that I configure preempt? A.