Contents
How can we achieve it with OSPF and VRRP?
I have divided full network into two layer 2 networks running their own VRRP at the core. To understand it more thoroughly, let assume there are two independent layer 2 networks running 5400zl at the core with VRRP configured. Now we want to connect these network together through OSPF. How can we achieve it?
How to configure VLT OSFP VRRP-Dell Community?
12-11-2020 04:16 AM 1. VLT to create VLT Domain and redundancy 2. VRRP active/active for the GateWay 3. OSPF to connect to other routers Question’s are, is it possible to utilize all that featuers together ? Is thing “VLT peer routing” needed to be configured ? How to configure properly OSPF in such environment? Solved! Go to Solution.
Is there an alternative to VRRP in os10?
Peer routing in OS10 is no longer considered as an alternative to VRRP as we did not implement certain features but it is helpful to optimize the traffic flow for routed connections (each peer can forward on behalf of it’s parter without utilizing the interconnect).
What are the problems with OSPF route advertisements?
Once this is working, you can focus on problems with route advertisements. Most of the times you are expecting to see something in the routing table while it’s not there or you see something different than what you are expecting.
Is the OSPF router connected to area 2?
Here’s the OSPF configuration of both routers: As you can see all networks have been advertised. Area 2 is not directly connected to area 0 so a virtual link has been created. However, not everything is working as expected. Take a look at the routing tables:
Where does OSPF advert network 10.10.1.1 / 32?
Looks like we are advertising network 10.10.1.1 /32 but this network is not configured on any interface. Network 1.1.1.1 /32 is configured on the loopback0 interface of R1. Here’s the configuration: We’ll make sure we have the correct network command configured here.