Can you ping different VLANs?
By design, all devices connecting through a Meraki AP can ping the AP’s Management Interface, even if they are on different VLANs. All other communication will follow the rules of the Inter-VLAN router. …
How do I ping across a VLAN?
Use a extended ping command by using the source address from an SVI interface you’ve created towards the IP address of the another SVI on this switch. Once these interfaces are up, and you have setup the IP addresses on the hosts belonging to them, you are able to see the ARP table for each L3 interface (SVI).
What is VLAN IP address?
Same thing, the VLANs IP address is a Switch Virtual Interface (commonly called a SVI), in essense it is an interface (albeit logical) and plays the same role as a routers interface which has an IP address. It provides a gateway for inter-VLAN or inter-routing traffic.
Why do different VLANs not Ping each other?
By default Vlans don’t ping each other as they are designed to fragment and isolate devices within the network (this is the logic when working on vlans on layer 2). If you wish to have Vlans communicating with each other then this is accomplished at layer 3 via a router. The process is called inter-vlan routing.
How can I ping the default gateway of VLAN 10?
Here is my problem. From PC vlan 10 i can ping the int vlan 20 on the switch, which has a totally different subnet. Also, from PC vlan 20, i can ping the default gateway of vlan 10. How is this possible without routing? I feel like everything I knew about networking is crumbling.
What are the options for routing between VLANs?
There are three options available in order to enable routing between the VLANs: Router with a Separate Physical Interface in each VLAN; Router with a Sub-Interface in each VLAN; Utilizing a Layer 3 Switch; The remainder of this article will explore these three options and their configuration. Router with Separate Physical Interfaces
Can a subnet communicate with a different VLAN?
No .. without ” ip routing enable ” Vlans on different subnets can not be routed and can not be communicated . By default , hosts on same VLANs can communicate among them . But cannot communicate on different VLANs host .