Contents
What is IPv6 static routing?
IPv6 Routing: Static Routing. Page 1. IPv6 Routing: Static Routing. This feature provides static routing for IPv6. Static routes are manually configured and define an explicit path between two networking devices.
How do I use static route in IPv6?
To configure a basic IPv6 static route, perform these steps.
- Enter global configuration mode. device# configure terminal.
- Designate the route destination as an IPv6 address in hexadecimal with 16-bit values between colons, as specified in RFC 2373, and include the address prefix length preceded by a slash.
What is IPv6 unicast routing command?
enable IPv6 routing on a Cisco router using the ipv6 unicast-routing global configuration command. This command globally enables IPv6 and must be the first command executed on the router. configure the IPv6 global unicast address on an interface using the ipv6 address address/prefix-length [eui-64] command.
Which IPv6 static route is configured?
IPv6 also has a default static route similar to the IPv4 quad zero (0.0. 0.0) static default route. Instead, the IPv6 command uses the ::/0 notation to specify all networks. For example, a default static route as specified by the “::/0” entry is configured on router R2 to reach all other networks connected to R1.
Why would you use static routing?
Static routing is often used as a complement to dynamic routing to provide a failsafe backup in the event that a dynamic route is unavailable. Static routing is often used to help transfer routing information from one routing protocol to another (routing redistribution).
What are the different types of static routing?
The following types of IPv4 and IPv6 static routes will be discussed:
- Standard static route.
- Default static route.
- Summary static route.
- Floating static route.
How to configure Cisco IPv6 unicast routing?
Use the Search field on Cisco.com to locate the Cisco IOS software documentation. For example, if you want information about static routes, you can enter Implementing Static Routes for IPv6 in the search field to learn about static routes. The switch supports only IPv6 unicast addresses.
How to configure a static route for IPv6?
Use the ipv6 route command in order to configure the static routing. Note that before you configure the router with a static IPv6 route, you must enable the forwarding of IPv6 packets with the ipv6 unicast-routing command in the global configuration mode. Prerequisites. Ensure that you meet these requirements before you attempt this configuration:
What are the prerequisites for IPv6 routing?
Prerequisites for IPv6 Routing: Static Routing. Before configuring the device with a static IPv6 route, you must enable the forwarding of IPv6 packets using the ipv6 unicast-routing global configuration command, enable IPv6 on at least one interface, and configure an IPv6 address on that interface.
Which is the active switch for unicast routing?
The active switch runs the IPv6 unicast routing protocols and computes the routing tables. They receive the tables and create hardware IPv6 routes for forwarding. The active switch also runs all IPv6 applications.