Contents
How does DHCP work with multiple subnets?
The DHCP Server Multiple Subnet feature enables multiple disjoint subnets to be configured under the same DHCP address pool. This functionality enables the DHCP server to manage additional IP addresses by adding the addresses to the existing DHCP address pool (instead of using a separate address pool).
Does a DHCP server need to be on the same subnet?
Not really, unfortunately. On the same subnet, you absolutely cannot run two DHCP servers that assign addresses from the same range. However, on the same subnet, you can have two DHCP servers that assign addresses from different ranges.
How to configure DHCP server to work with VLANs?
The first step is to install the DHCP server role: Then open the DHCP management panel: Right-click on IPv4 and select New Scope, a Wizard will start: Specify the range of IP addresses that will be assigned by the scope. Note, we are configuring a scope for the VLAN 10 (IP range 192.168.1.xyz):
Is it possible to setup multiple VLANs on a single NIC?
Please use technology-specific Windows Server forums for areas like File Server and Storage, High Availability (Clustering), Directory Services, etc. 0 1 We are setting up physical Windows 2016 standard server, We are trying to see if it is possible to have multiple VLANS on single NIC Teaming?
How to configure VLAN on Windows Server 2016?
In Windows Server 2016, you can configure VLAN using built-in tools, you don’t need to install any special drivers or utilities. Let’s try to configure some different VLANs on a single physical network adapter on Windows Server 2016 using NIC Teaming. Make sure that no VLAN number is set in the network adapter advanced settings (VLAN ID = 0).
Do you need to relay DHCP requests for VLAN 102?
Since the Windows server is already in VLAN 102, it will directly server this VLAN and you only need to relay DHCP requests for VLAN 101. On the switch, the ports that connect to hosts (computers, servers) must be set as access for the desired VLAN.