Contents
What are types of IPv6 static routes?
How to configure IPv6 Static Route
- Static floating route – outgoing interface.
- Static floating route – global unicast next hop.
- Static floating route – link-local next hop.
What is the default ad of an IPv6 static route?
The IPv6 default route (::/0) is a static route used for all traffic that has a destination network not reachable through any other IPv6 route in the routing table. For more information on static routes, see IPv6 static routing.
What is the command to configure IPv6 static route?
To configure a basic IPv6 static route, perform these steps.
- Enter global configuration mode. device# configure terminal.
- Designate the route destination as an IPv6 address in hexadecimal with 16-bit values between colons, as specified in RFC 2373, and include the address prefix length preceded by a slash.
What is a floating static route?
Floating static routes are static routes that have an administrative distance greater than the administrative distance of another static route or dynamic routes. By default, static routes have an administrative distance of 1, making them preferable to routes learned from dynamic routing protocols.
Does IPv6 have a default gateway?
The ipv6-default-gateway command designates the default IPv6 gateway that the interface can reach. Define a default IPv6 gateway if you defined IPv6 IP addresses. If the interface supports both IP families, use the ipv4-default-gateway command to designate the default IPv4 gateway.
What characterizes a floating static route?
Floating static routes are static routes used to provide a backup path to a primary static or dynamic route, in the event of a link failure. They must be configured with a higher administrative distance than the original dynamic routing protocol has. A default static route is simply a static route with 0.0.
What are two advantages of static routing?
Static routing provides some advantages over dynamic routing, including:
- Static routes are not advertised over the network, resulting in better security.
- Static routes use less bandwidth than dynamic routing protocols, as routers do not exchange routes.
- No CPU cycles are used to calculate and communicate routes.
Types of IPv6 Static and Default Routes. There are three types of IPv6 static and default routes: Directly Connected IPv6 Static Route – A directly connected static route is enabled when an outgoing interface is specified. A directly connected static route is normally used with a point-to-point serial interface.
What is static routing in Cisco Networking?
Static Route is a fixed, manually configured routing record applied to routers. Since these records create manually, they must also be deleted manually at any time. What is a Static Route? Routes are used to determine where the IP packet is sent to a router on the network. Each interface on Cisco Routers refers to an IP network.
What is a static IP route?
A static IP route specifies the route’s destination address and the next-hop router’s IP address or routing switch interface through which the routing switch can reach the destination. (The route is added to the routing switch’s IP route table.)
What is a static routing table?
Static routing is simply the process of manually entering routes into a device’s routing table via a configuration file that is loaded when the routing device starts up.
https://www.youtube.com/watch?v=hDCSdUcurPY