How do I create a route between two subnets?

How do I create a route between two subnets?

The static routes should be configured with:

1. Destination LAN NET – The remote subnet that you are creating the route for.
2. Subnet Mask – The subnet mask of the remote subnet.
3. Gateway – This must be set to the IP address of the next hop to the destination subnet which in this case is the WAN IP of Router2 and Router3.

Which command is used to create the static route?

IP route command is used to configure the static route. Static routes are the most secure way of routing.

How many route tables can be on a subnet?

one route table
A route table can be associated with multiple subnets. However, a subnet can only be associated with one route table at a time. Any subnet not explicitly associated with a table is implicitly associated with the main route table by default.

What is persistent route?

You use the route command to manually manipulate the network routing tables. Using the route command is the only way that you can manually make routes persistent across system reboots. To make the changes persist across system reboots, use the –p option with the route command.

What does it mean to use static routing in SonicWall?

Static routing means configuring the SonicWALL to route network traffic to a specific, predefined destination. Static routes must be defines if the LAN, WAN, or other defined interface is segmented into subnets, either for size or practical considerations.

What are the IP addresses of SonicWall subnets?

Destination Network – the network IP address of the remote subnet. The address usually ends in 0, such as 10.0.5.0. Subnet Mask – the subnet mask of the remote network, such as 255.255.255.0. Gateway – the IP address of the internal (LAN) router that is local to the SonicWALL.

How can I configure multiple networks with SonicWall?

Provide the subnet mask. Give a friendly comment for the interface. Enable the management if needed and click OK. By default, the access between the trusted zones is allowed. To deny access from LAN to the server zone, you need to edit the default access rule and set it to deny.

When to use static routes on a router?

Static Routes are configured when network traffic is directed to subnets located behind routers on your network. For example, you have a router on your network with the IP address of 192.168.168.254, and there is another subnet on your network with an IP address range of 10.0.5.0 – 10.0.5.254 with a subnet mask of 255.255.255.0.