How do I set static route in IPv6?

How do I set static route in IPv6?

To configure a basic IPv6 static route, perform these steps.

1. Enter global configuration mode. device# configure terminal.
2. Designate the route destination as an IPv6 address in hexadecimal with 16-bit values between colons, as specified in RFC 2373, and include the address prefix length preceded by a slash.

How do I add an IPv6 route?

Creating an IPv6 route using System i Navigator

1. In System i Navigator, expand Network > TCP/IP Configuration > IPv6.
2. Right-click Routes, and select New Route.
3. Follow the steps in the New IPv6 Route wizard to create an IPv6 route.

How configure IPv6 on UDM pro?

Configuring Static IPv6 Addresses

1. Navigate to the. Settings > Internet > WAN Networks section.
2. Set the IPv6 Connection Type to Static IP and add the information obtained from your ISP.
3. Apply the settings.
4. Navigate to the.
5. Set the IPv6 Connection Type to Static and fill in the other information.
6. Apply the changes.

What is my IPv6 prefix delegation size?

Each hexadecimal character in an IPv6 prefix represents one nibble, which is 4 bits. The length of a delegated prefix should therefore always be a multiple of 4. A single network at a customer site will be a /64.

What is the right command in order to configure IPv6 static route?

How to configure IPv6 Static Route

• Static host route – outgoing interface.
• Static host route – global unicast next hop.
• Static host route – link-local next hop.

How do I add IPv6 route to Windows 10?

Install IPv6

1. Click Start, click Control Panel, and then double-click Network Connections.
2. Right-click any local area connection, and then click Properties.
3. Click Install.
4. Click Protocol, and then click Add.
5. Click Microsoft TCP/IP version 6, and then click OK.
6. Click Close to save changes to your network connection.

How to configure IPv6 DCHP-PD on Ubiquiti edgerouter-Pentanet?

The below configuration commands can be used to configure IPv6 DCHP-PD on a Ubiquiti Edgerouter running EdgeOS that has an existing IPv4 PPPoE configuration. This has been tested with version 2.0.4 but should also work on earlier versions.

How to configure public static IP addresses in edgerouter?

1. Navigate to the Dashboard tab and assign the IP address (es) to the WAN interface. 2. Navigate to the System tab in the bottom-left of the web UI to add the default gateway and DNS servers. CLI: Access the EdgeRouter Command Line Interface. 1. Enter configuration mode.

How do I set up edgerouter for IPv6?

You simply need to turn on ipv6, address and autoconf. After setting these settings, restart your EdgeOS router. You should have working configurations on your edgerouter for IPv6. Your interfaces should look similar to this

What is the eth0 ID for Ubiquiti edgerouter?

This has been tested with version 2.0.4 but should also work on earlier versions. The following assumes that your PPPoE interface is running on eth0, tagged with VLAN ID 100, and that your local bridge interface is named switch0 – if your configuration varies, please adjust this as necessary.