Contents
How do I connect to IPsec?
Configuring the Server side
- In the administration interface, go to Interfaces.
- Double-click on VPN Server.
- In the VPN Server Properties dialog box, check Enable IPsec VPN Server.
- On tab IPsec VPN, select a valid SSL certificate in the Certificate pop-up list.
- Check Use preshared key and type the key.
- Save the settings.
How can you secure a remote connection between two private networks over the Internet?
The standard solution is to use use a VPN between two routers, and you adjust the routing so all LAN-to-LAN traffic crosses the VPN.
How to configure IPsec tunnel private to private?
You use access control lists (ACLs) to tell the router not to do Network Address Translation (NAT) to the private-to-private network traffic, which is then encrypted and placed on the tunnel as it leaves the router. There is also a static NAT for an inside server on the 10.1.1.x network in this sample configuration.
How to create a VPN connection between two vnets?
In the following steps, you create two virtual networks along with their respective gateway subnets and configurations. You then create a VPN connection between the two VNets. It’s important to plan the IP address ranges for your network configuration.
When do you need two separate internet connections?
There are times when having two separate networks – both sharing the same Internet connection – can come in handy. For example, I recently helped a community center with its network setup. They needed to provide Internet connection to tenants who were renting space, in addition to their own shared Internet.
How does Internet Protocol security protocol ( IPsec ) work?
IPsec —Internet Protocol Security Protocol (IPsec) provides enhanced security features such as stronger encryption algorithms and more comprehensive authentication. IPsec has two encryption modes: tunnel and transport. Tunnel mode encrypts the header and the payload of each packet while transport mode only encrypts the payload.