Contents
Can you connect two switches to a router?
Theoretically, the number of network switches that can be connected to a router is infinite. A process known as daisy-chaining allows you to connect as many switches together as you wish, however, this is not recommended as it does come with the risk of creating a loop if they are not connected correctly.
How do I configure two Cisco switches?
To configure a LAN port for Layer 2 switching, perform this task: After you enter the switchport command, the default mode is switchport mode dynamic desirable. If the neighboring port supports trunking and is configured to allow trunking, the link becomes a Layer 2 trunk when you enter the switchport command.
How do I connect 3 switches to my router?
Option 1: Connect all three switched directly to the router, if your router have enough Ethernet ports and then enable Dot1Q encapsulation to enable inter VLAN routing (if your switches are not L3; couple of switches give you both the features).
Is it possible to have 2 switches connected to 1 router?
Unmanaged switches will just send the connection to the ports that are connected to by MAC Address,That is Very true but if Sohail uses say 3-4 switches by time the connection gets to Switch 3 or Switch 4 the connection would have suffered. Thats what im saying. Click to expand…
How to connect 2901 router to 2 switches?
I have connected 2901 router to 2 switches (2960). Vlan 10 is configured in switch 1 and Vlan 20 is configured in switch 2. Ip address of host in switch 1 is 192.168.1.10 and ip address of host in switch 2 is 192.168.2.10. I need to communicate between the 2 hosts. But Its not communicating.
What’s the best way to connect two switches?
Switch A we assign an IP address to VLAN 3 and enabling routing on the VLAN. On both switch A and switch B we will keep things simple and use interface 1/e1 for the connection between each switch. Setting both switches 1/e1 to general mode, allowing the additional VLAN 2,3, and keeping the PVID of 1.
How to connect a switch to an external router?
On switch A we configure a static route to help traffic to the next hop in the network, which is the router. The external router will also need a path defined back to all networks/VLANs. To check the status of a port we can use the command.