Contents
What is no Switchport mode?
The no switchport command puts the interface in L3 mode (known as “routed port”) and makes it operate more like a router interface rather than a switch port. The ip address command assigns an IP address and network mask to the interface. Routed ports can be configured with a Layer 3 routing protocol.
What is no Switchport VLAN?
Answers Explanation & Hints: When the no switchport access vlan command is entered, the port is returned to the default VLAN 1. The port will remain active as a member of VLAN 1, and VLAN 30 will still be intact, even if no other ports are associated with it.
What is Switchport mode command?
Using the “Switchport mode access” command forces the port to be an access port while and any device plugged into this port will only be able to communicate with other devices that are in the same VLAN. Using the “Switchport mode trunk” command forces the port to be trunk port.
How do I configure a port on a switch?
To configure the switch so that you can connect an appropriate device to a port and have it work, follow these steps: Connect to your switch and get into Configuration mode using a set of commands like the following: Switch1>enable Password: Switch1#configure terminal Enter configuration commands, one per line.
How does router on a stick work?
ROUTER-ON-A-STICK, also known as a “one-armed router” is a method for running multiple VLANs over a single connection in order to provide inter-VLAN routing without the need of a Layer 3 switch. Essentially the router connects to a core switch with a single interface and acts as the relay point between networks.
What is difference between access mode and trunk mode?
An access port is a connection on a switch that transmits data to and from a specific VLAN. A trunk port allows you to send all those signals for each switch or router across a single trunk link. In contrast to an access port, a trunk port must use tagging in order to allow signals to get to the correct endpoint.
Which command is used to remove the trunk mode of a port?
Table 3-7 Resetting Configures Values on Trunk Lines
| Enter global configuration mode. | S1# configure terminal |
|---|---|
| Configure the port in access mode. | S1(config-if)# switchport mode access |
| Optionally, remove the trunk mode if it was entered. | S1(config-if)# no switchport trunk encapsulation [dot1q | isl] |
What is the purpose of the switchport command?
You only use the switchport command on switches—not routers. It can put a port into trunk mode, into a certain VLAN, or even to set port security. Its most common use is to configure an interface to connect to an access device (e.g., workstation, server, printer, etc.).
What does the command “switchport mode access” do?
switch(config-if)# switchport mode access This above command disables DTP – Dynamic Trunking Protocol on the specified interface and basically turns off trunk negotiation. This command is important for any access port setting because without this command the port can be easily setup as a trunk interface.
What is switchport mode trunk?
Switchport trunk means when you have a trunk link, all VLANs are allowed to pass through a trunk link. To configure a trunk on a switch FastEthernet port, use the switchport mode trunk command. This command puts the interface into permanent trunking mode and negotiates to convert the neighboring switch or links into trunk links.