How do I get my SonicWall out of safe mode?

How do I get my SonicWall out of safe mode?

Use a paperclip or toothpick to press and hold the reset button on the back of the appliance for ten to fifteen seconds. The reset button is in a small hole next to the console port or next to the power supply, depending on the SonicWall model.

What is SonicWall safe mode?

The SafeMode feature allows you to recover quickly from uncertain configuration states with a simplified management interface that includes the same settings available on the System > Settings page. The Test light begins to blink when the Dell SonicWALL security appliance has rebooted into SafeMode.

How do I console SonicWall?

EXAMPLE: If the LAN IP address of your SonicWall appliance is 192.168. 168.1, you can log into it by typing https://192.168.168.1. EXAMPLE: If you configure the port to be 76, then you must enter http://192.168.168.1:76 into the Web browser.

How do I reset my SonicWall NSa 2650?

Hold down the reset button for 10 seconds. On a TZ the reset button is located next to the power jack. On an NSa the reset button is located on the front. Once the test light on the device becomes solid or begins to blink then the SonicWall is in safe mode.

How do I reset my SonicWall NSa 5600?

Push and hold the reset button for 10 seconds, then navigate to “http://192.168.168.168” in a web browser to reconfigure the appliance.

How do I get to SonicWall settings?

Open an Internet browser and enter 192.168. 168.168 in the address bar. As this is the first time you are accessing the SonicWall UTM management interface, you will be presented with a wizard. You could follow the wizard to set a new admin password and other information.

How can I put the SonicWall into safe mode?

The SonicWall will reboot and enter safe mode. Reference the steps above to login to the safe mode GUI, beginning with “Connect a computer directly to the following Interface…” Download the desired firmware version from MySonicWall.com or have the desired ROM Version on hand. ROM Packs are only available via SonicWall technical support.

What is the password for the SonicWall appliance?

For instance, if a CLI session goes to the config level, it will ask you if you want to preempt an administrator who is at config level in the GUI or CLI session. The SonicWall CLI currently uses the administrator’s password to obtain access. SonicWall devices are shipped with a default password of password.

How can I change the IP address of my SonicWall?

Use the Cross-Over cable to connect a windows computer directly to the LAN port of the SonicWall. Run the SetupTool to discover the SonicWall’s IP address. Change the IP address of the computer to be on the same subnet and try to access the SonicWall management page with the current IP address of the SonicWall.

How to access SonicWall management interface from the LAN?

1 Use the Cross-Over cable to connect a windows computer directly to the LAN port of the SonicWall. 2 Run the SetupTool to discover the SonicWall’s IP address. 3 Change the IP address of the computer to be on the same subnet and try to access the SonicWall management page with the current IP address of the SonicWall.