Contents
How do I connect my HP Procurve switch to PuTTY?
1. Connect the Console and Serial adapter together (Female end to the Serial Male end). Locate the Console port on your HP Procurve Switch and plug the console cable into the port, It’s usually located at the front of the device under the logo.
How do I access my HP Procurve console port?
To connect a console to the switch, use the console cable shipped with the switch and connect a PC or VT-100 terminal to the console serial port. The PC or terminal then functions as a management console connected directly to the switch.
How do I access the HP Procurve switch web interface?
To enable web login, log in to the device via the console port, and perform the following configuration: • Enable HTTP or HTTPS service • Configure the IP address of the VLAN interface • Configure a username and password The device supports the following web login methods: • HTTP login: • HTTPS login: The following …
How do I use PuTTY with a USB cable?
How to Connect Cisco Device via USB Cable Using Putty
- Login to Cisco’s support site and download the Cisco USB Console driver.
- Plug in USB cable to Cisco device and PC.
- From your PC open Device Manage à Ports should now show the Cisco Serial (COM3) listed.
How do I put my HP switch into control mode?
Configuration commands and the context configuration modes
- HP Switch(config)# interface c3-c6. HP Switch(eth-C5-C8)#
- HP Switch(eth-C5-C8)# HP Switch(eth-Trk1)#
- HP Switch(config)# vlan 100. Command executed at configuration level to enter VLAN 100 context.
- HP Switch(vlan-100)#
- HP Switch(vlan-100)#?
How do I reset my HP switch password?
If you lose or have forgotten a switch password: Solution: You can clear the switch password by pressing the recessed Clear button on the front of the switch. This action deletes all password and user name protection from all of the switch’s interfaces.
How do I setup my HP 1920 switch?
Initial configuration
- Place the switch close to the PC that will use for configuration.
- Connect power to the switch, and then start the PC (If it is not already running) and wait until the switch and PC have finished their start-up sequences.
- Connect the PC to any port on the switch using a standard Ethernet LAN cable.
Is there a serial port for the HP ProCurve 2512?
I have a HP Procurve 2512 switch which sits in between our Leased Line Router & our Watchguard Firewalls to allow for HA. I need to make changes to the switch ports but i can’t seem to get PuTTY to speak to the switch at all. I’m using a HP Serial cable connected to a HP DL180G6 server (serial port : COM1) to connect directly to the switch.
How to connect a HP ProCurve switch to a computer?
Connecting to a HP ProCurve Switch Using a Console cable & Putty. Before you begin: You will need a Console cable and a serial adapter (most computers/laptops nowadays no longer come with a serial port) Console Cable: Serial to USB Adapter: 1. Connect the Console and Serial adapter together (Female end to the Serial Male end).
Where is the console cable on a HP ProCurve?
Connect the Console and Serial adapter together (Female end to the Serial Male end). Locate the Console port on your HP Procurve Switch and plug the console cable into the port, It’s usually located at the front of the device under the logo.
Why is my serial port not working on my hp2512?
If you see nothing here, but your loopback test is successful, you either have the wrong cable or the serial port on the switch is faulty. If you happen to have an oscilloscope at your disposal, you can test pin 2 and 3 during bootup for the data stream and determine the correct speed and cable.