Contents
Does NAT work for UDP?
UDP hole punching is a commonly used technique employed in network address translation (NAT) applications for maintaining User Datagram Protocol (UDP) packet streams that traverse the NAT. UDP hole punching establishes connectivity between two hosts communicating across one or more network address translators.
Does UDP have a source port?
User datagram protocol (UDP) operates on top of the Internet Protocol (IP) to transmit datagrams over a network. UDP does not require the source and destination to establish a three-way handshake before transmission takes place. Additionally, there is no need for an end-to-end connection.
When NAT hides the source IP of an originating device this is known as?
Answer: when Nat hides the source of IP of an organisation device this is known as IP masquerading.
Does UDP work over Internet?
With UDP, the client or server can send the latest player/game state in individual packets that do not depend on arriving in order. If a packet is late, or arrives out of order… it should be ignored. UDP is good for communications that need to be fast, but losing individual packets is OK.
How does nat work with incoming UDP packets from unknown?
My understanding of NAT is that UDP packets going out from the client to a specific endpoint will result in a temporary entry into the NAT table mapping the source port to the destination endpoint. (Is this right?)
Why does Nat translate a source port ( Pat )?
A NAT ( Network Address Translation) does not actually translate the port. You are most likely referring to a PAT ( Port Address Translation). Even more specifically, you are likely referring to a Dynamic PAT — which is a type of translation which allows any number of internal hosts to share one or more public IP addresses:
How is the outbound port determined for a NATed connection?
The NAT is going to decide/determine the outbound port for a NATed connection/session, via it’s own internal means. Meaning, it will vary according to the implementation of the NAT. This means any responses back will come back to that same outbound port.
Why does NAPT translate both IPv4 and UDP ports?
NAPT translates both the IPv4 address and the transport address (TCP port, UDP port, or ICMP identifier). The reason is that there may be multiple hosts using the NAT which could be using the same protocol with the same transport address (port or identifier). There are different types of NAT.