How do I set a static default route without next hop?

How do I set a static default route without next hop?

Configuring a default static route

1. Enter global configuration mode. device# configure terminal.
2. Enter 0.0. 0.0 0.0.
3. (Optional) Enable the default network route for static route next-hop resolution.
4. (Optional) Configure next-hop recursive lookup to resolve the next-hop gateway.

How do I tag a static route?

You can also specify a “tag” when configuring a static route. This is done by using the keyword “tag”, like this: Router(config)#ip route 10.2….A route can appear in the routing table if it is:

1. Connected – directly attached.
2. Dynamic – learned via a routing protocol.
3. Static – configured by a person.

Is route add permanent?

After adding a static route it will be active until the next restart of your Windows PC. To make the route persistent just add the -p option to the command. For Example: route -p add 192.168.

How do I change the administrative distance of a static route?

To set an administrative distance:

1. For RIP and OSPF, issue the distance command in Router Configuration mode. host1(config-router)#distance 100. The range for administrative distance is 0–255.
2. For IS-IS, issue the distance ip command in Router Configuration mode. host1(config-router)#distance 80 ip.

What is the purpose of a floating static route?

A floating static route is used as a backup route. It has a manually configured administrative distance greater than that of the primary route and therefore would not be in the routing table until the primary route fails. You will test failover to the backup route, and then restore connectivity to the primary route.

What happens if the standby router does not run HSRP?

This router is known as the active router. Another router is elected as the standby router. If the active router fails, the standby assumes the packet forwarding duties. Although an arbitrary number of routers may run HSRP, only the active router forwards the packets that are sent to the virtual router IP address.

Which is the only address available for HSRP?

These three addresses are the only addresses available for use with HSRP: Therefore, you can configure only three HSRP groups on Token Ring interfaces, unless you configure the standby use-bia parameter. HSRP peer routers that protect a subnet are able to provide access to all other subnets in the network.

Is it possible to ping both HSRP routers?

This led to the same situation as above (Ping possible, HSRP both active), so I changed back to our standard-configuration. The Vlan used to work at least three weeks ago. We are not aware of any relevant changes since then (we did attach more Access-Switches via vPC-Uplinks, though). Solved! Go to Solution. 11-11-2011 01:05 AM 11-11-2011 01:05 AM

Is the HSRP active on VL 783 or N2?

Both Nexus think that they are HSRP Active on Vl 783. Standby-Router is unknown. => on N2 (which should be Standby. IP: .12), only the following lines are repeating: 2011 Oct 11 16:58:36.880624 hsrp: Vlan783 [1/V4]: Hello out Active pri 130 ip 10.34.195.10 2011 Oct 11 16:58:36.880651 hsrp: Vlan783 [1/V4]: hel 0 hol 0 auth somethingelse