Contents
How can I configure an interface as secondary WAN port in SonicWall?
Please click Network option on the top row and navigate to System| Interfaces page, configure the chosen port to be in WAN zone, and enter in the correct address settings provided by the Secondary ISP. Any interface added to the WAN zone by default creates a NAT Policy allowing internal LAN subnets to NAT out this secondary WAN interface
What is portshield switch mode on SonicWall TZ 210?
PortShield Switch Mode —For SonicWALL TZ 210, TZ 210W and NSA 240 appliances, you can configure interfaces for PortShield switch mode that manually groups ports together to share a common network subnet as well as common zone settings. For more information, refer to Configuring PortShield Groups .
How are wire mode rules applied in SonicWall?
Access rules are applied to the Wire Mode pair based on the direction of traffic between the source Zone and its Paired Interface Zone. For example, if the source Zone is WAN and the Paired Interface Zone is LAN, then WAN to LAN and LAN to WAN rules are applied, depending on the direction of the traffic.
Where do I enter my IP address in SonicWall?
Enter the IP Address (Primary), and the IP Address (Secondary) if high availability is enabled, and the Subnet Mask of the zone in the IP Address (Primary), IP Address (Secondary), and Subnet Mask fields. NOTE: You cannot enter an IP address that is in the same subnet as another zone.
Do you need a DMZ for a SonicWall?
To clarify, I need to configure the sonicwall to: Give a public IP address (from Comcast modem) to a device on the network. Assign a private IP to that device as well, accessible from LAN. Said public IP address must be a DMZ (no firewall). What is the best way to accomplish this?
What are the optional protocols for SonicWall 6.2?
Ping, SNMP and/or SSH are optional protocols that can also be enabled. If you want to allow selected users with limited management rights to log in to the security appliance, select HTTP and/or HTTPS in User Login. Click OK to save changes. The below resolution is for customers using SonicOS 6.2 and earlier firmware.
How does SonicWall work on the opt interface?
Transparent Mode enables the SonicWall security appliance to bridge the OPT subnet onto the WAN interface. It requires valid IP addresses for all computers connected to the OPT interface on your network, but allows remote access to authenticated users.