Contents
How do I add a RADIUS server to WLC?
From the WLC GUI, click Security. From the menu on the left, click RADIUS > Authentication. The RADIUS Authentication servers page appears. To add a new RADIUS Server, click New.
How Configure Cisco ISE RADIUS server?
This is the procedure to add a device on ISE :
- Navigate to Administration > Network Resources > Network Devices > Add.
- Give a name and the IP address.
- The Device Profile can be chosen from the dropdown list to be the one defined in the previous section.
- Check Radius Authentication Settings.
Can a Cisco router be a RADIUS server?
No you can’t set the router as a server. Local auth is not RADIUS. The whole point of a RADIUS is to use a different machine for authentication purpose. The IP you set with radius-server host must be that of the RAIDUS server.
How do I access Cisco WLC GUI?
Both the wired and wireless clients can access the dynamic interface of the controller using the CLI and GUI. To access the GUI of the controller enter the dynamic interface IP address of the controller in the address field of either Internet Explorer or Mozilla Firefox browser.
What is a radius controller?
Remote Authentication Dial-In User Service (RADIUS) is a client/server protocol that provides centralized security for users attempting to gain management access to a network.
How do you set a RADIUS on a Cisco router?
To configure RADIUS on your Cisco device or access server, you must perform these tasks:
- Use the aaa new-model global configuration command to enable Authentication, Authorization, and Accounting (AAA).
- Use the aaa authentication global configuration command to define method lists for RADIUS authentication.
How do I upload a config file to Cisco WLC?
Now you are ready to upload WLC config on to your TFTP server from WLC CLI console. Follow the below screenshot & you can see the CLI commands required. (WLC1) >transfer upload mode tftp (WLC1) >transfer upload datatype config (WLC1) >transfer upload filename wlc-backup-2013-01-25 (WLC1) >transfer upload path .
How do I add an access point to my Cisco wireless controller?
From the WLC controller GUI, click Security > AP Policies. and the AP Policies page appears. Click the Add button on the right hand side of the screen. Under Add AP to Authorization List, enter the AP MAC address (NOT the AP Radio mac address).
How to configure radius for GUI and CLI authentication?
First, configure on the WLC and on ISE for RADIUS authentication, and later perform the same for TACACS+. Step 1. Declare the RADIUS server. Firstly, create the RADIUS server ISE on the WLC.
How to check if RADIUS server is managed by Cisco?
Verify whether the WLC is configured to be managed by Cisco Secure ACS. In order to do this, click Security from the WLC GUI. The resultant GUI window appears similar to this example. You can see that the Management check box is enabled for RADIUS server 172.16.1.1.
How to configure management users on the WLC?
You can also configure the management users locally on the WLC. This can be done from the controller GUI, under Management > Local Management Users. Assume that the WLC is configured with management users both locally as well as in the RADIUS server with the Management check box enabled.
How to configure radius and TACACS + for GUI?
Create an AAA authentication login method that points to the Tacacs+ server group. Always in the GUI page, https:// /webui/#/aaa, move to the AAA Method list tab, and create the Authentication method as shown in the image. In the popup, give a name to the method, select type as login, and assign the group server created in the previous step.