Contents
Can you describe the Spanning Tree Protocol?
Spanning Tree Protocol (STP) is a link management protocol that provides path redundancy while preventing undesirable loops in the network. When it comes to ethernet networks, only one active path can exist between two stations in order for them to function properly. Loops occur in networks for a variety of reasons.
What is the Spanning Tree Protocol What is it used for?
The Spanning Tree Protocol (STP) is a network protocol that builds a loop-free logical topology for Ethernet networks. The basic function of STP is to prevent bridge loops and the broadcast radiation that results from them.
What is Spanning Tree Protocol STP and how does it prevent loops?
The Spanning Tree Protocol (STP) is a network protocol that is used to eliminate bridge loops in Ethernet LANs. STP prevents network loops and associated network outage by blocking redundant links or paths. The redundant paths can be used to keep the network operational if the primary link fails.
What are the types of spanning tree protocol?
Spanning-Tree Protocol Types
| Protocol | Standard | Convergence |
|---|---|---|
| STP | 802.1D | Slow |
| PVST+ | Cisco | Slow |
| RSTP | 802.1w | Fast |
| Rapid PVST+ | Cisco | Fast |
What is spanning tree protocol and how it work?
The Spanning Tree Protocol (STP) is a network protocol that ensures a loop-free topology for any bridged Ethernet local area network. The basic function of STP is to prevent bridge loops and ensuing broadcast radiation .
What is the purpose of spanning tree protocol in?
The Spanning Tree Protocol (STP) is a network protocol that builds a loop-free logical topology for Ethernet networks. The basic function of STP is to prevent bridge loops and the broadcast radiation that results from them. Spanning tree also allows a network design to include backup links providing fault tolerance if an active link fails.
Should I enable spanning tree?
All switches from Cisco ship with Spanning Tree Protocol (STP) enabled by default, but if STP is misconfigured for any reason, you can easily enable it. To enable spanning tree, connect to your switch and type spanning-tree mode while in Global Configuration mode.
What is spanning tree and why use spanning tree?
Spanning tree protocol (STP) is a Layer 2 network protocol used to prevent looping within a network topology. STP was created to avoid the problems that arise when computers compete for the ability to use the shared telecommunications path on a local area network ( LAN ). When too many computers try to send at the same time, overall network performance is affected and can bring all traffic to a near halt.