Contents
Can two switches have the same IP address?
Yes this is possible.
How do I connect a switch to a IP address?
Configure an IP address on a switch
- enter the VLAN 1 configuration mode with the interface vlan 1 global configuration command.
- assign an IP address with the ip address IP_ADDRESS SUBNET_MASK interface subcommand.
- enable the VLAN 1 interface with the no shutdown interface subcommand.
Can you connect switches together?
If a single switch doesn’t have enough ports for your entire network, you can connect switches by daisy-chaining them, as shown below. You can daisy-chain network switches together. On most switches, it doesn’t matter which port you use to daisy chain to another switch.
What is the switch IP address?
The IP address of the switch can be manually configured or automatically received from a Dynamic Host Configuration Protocol (DHCP) server. If there are no DHCP servers available, the switch will use its factory default IP address which is 192.168. 1.254.
Is it possible to connect two switches with different IP ranges?
Yes. If you don’t have a router all your devices must have ip-addresses in the same subnet for them to be able to reach each other over TCP/IP. (The switches themselves must also be connected, obviously.) I’m trying to be able to ping all the devices no matter which switch they are connected to. is it possible?
How to assign an IP address to a switch?
Usually, the default VLAN 1 acts like the switch’s own NIC for connecting into a LAN to send IP packets. Here are the steps to configure an IP address under VLAN 1: enter the VLAN 1 configuration mode with the interface vlan 1 global configuration command. assign an IP address with the ip address IP_ADDRESS SUBNET_MASK interface subcommand.
Is it possible to connect two networks with the same IP address?
Router 1 is assigned IP address 192.168.3.1/24 in the bridging network and 192.168.1.251 in its own network. Router 1 has a connection to one of the 192.168.1.0/24 networks and NATs 192.168.1.x to and from 192.168.10.x
What’s the best way to connect two switches?
Switch A we assign an IP address to VLAN 3 and enabling routing on the VLAN. On both switch A and switch B we will keep things simple and use interface 1/e1 for the connection between each switch. Setting both switches 1/e1 to general mode, allowing the additional VLAN 2,3, and keeping the PVID of 1.