Contents
What is VCP in Juniper?
Virtual Chassis Port (VCP) Interface Names in an EX8200 Virtual Chassis | Virtual Chassis User Guide for EX8200 Switches | Juniper Networks TechLibrary.
Is vPC a Lacp?
Domain ID, System ID, and LACP. vPC still uses LACP. The devices that connect to vPC use normal etherchannels or LAGs.
What is Cisco vPC?
vPC (Virtual Port-Channel), also known as multichassis EtherChannel (MEC) is a feature on the Cisco Nexus switches that provides the ability to configure a Port-Channel across multiple switches (i.e. vPC peers). vPC is similar to Virtual Switch System (VSS) on the Catalyst 6500s.
Is vPC Cisco proprietary?
VPC or Virtual Port Channel is a Cisco proprietary feature available on the Nexus platform. Two switches of the same model can be combined into a VPC pair, which can establish a single EtherChannel, also known as a link aggregate or a port channel, across both switches to a third switch or server.
How does MC lag work?
An MC-LAG provides redundancy and load balancing between the two MC-LAG peers, multihoming support, and a loop-free Layer 2 network without running STP. LACP is used to discover multiple links from a client device connected to an MC-LAG peer. LACP must be configured on both MC-LAG peers for an MC-LAG to work correctly.
Is MLAG the same as vPC?
MLAG is a public protocol which could be supported by almost every vendor using their own custom rolled implementation, while VPC is a Cisco Nexus specific protocol, not all the vendors could have this technology in hand. Thus, MLAG setup is a bit easier than VPC.
How to verify a VPN connection between Juniper firewall and Cisco?
How to verify the VPN connection. In this scenario, the Juniper firewall is setup with a policy-based VPN and the policy matches the Access-list configured on the PIX. set ike gateway “To-Cisco” address 2.2.2.1 Main outgoing-interface “ethernet1” preshare “netscreen” proposal “pre-g2-des-sha”
Is there an analog of VPC in Juniper?
Although Juniper have an analog of vPC, greatly works on MX series routers. They calling it directly “MC-LAG”, which additionally uses ICCP to communicating between MC-LAG nodes. Those technologies well discribed in the book “Juniper MX Series” by Douglas Richard Hanks, Jr. and Harry Reynolds. Thanks for this.
How to setup a VPN between Juniper Netscreen and Pix?
How to setup VPN between PIX and Juniper Netscreen Firewall with a single access list. Policy-based VPN is suited for multiple access lists. How to verify the VPN connection. In this scenario, the Juniper firewall is setup with a policy-based VPN and the policy matches the Access-list configured on the PIX.
How big is juniper T640 Cisco CRS-1 rack size?
not present Juniper T640 Cisco CRS-1 Rack Size half (19“) half (proprietary) Max Throughput per slot * 40 Gbps * 40 Gbps * Slot numbers 8 4 Total Throughput * 320 Gbps * 160 Gbps *