Contents
How does SolarWinds calculate bandwidth?
To calculate how much bandwidth is required for monitoring 1 interface for 1 hour, multiply the number of polls per hour by the data per poll required by individual poll types. SolarWinds NPM requires 44.4 KB/hr to fully monitor 1 interface, using default polling intervals.
What is ifHCOutOctets?
ifHCOutOctets OBJECT-TYPE SYNTAX Counter ACCESS read-only STATUS mandatory DESCRIPTION “The total number of octets transmitted out of the interface, including framing characters. This object is a 64-bit version of ifOutOctets.
How do I check my HFSS bandwidth?
Using Results > Rectangular plots plot the return loss (s11) in dB against frequency. -10dB line should cut your curve at at least 2 points. The difference between the frequencies of those two points gives the bandwidth of your antenna. Originally Answered: I have designed my antenna on HFSS.
Which is MiB should I use for interface counters?
Q. Which MIB should I use for interface counters? A. Interface management over SNMP is based on two tables: ifTable ( registered customers only) and its extension, ifXTable ( registered customers only) described in RFC1213/RFC2233.
How to monitor the bandwidth of a VLAN?
That’s all SNMP will give you with respect to bandwidth; every SNMP monitoring station on the planet (such as cacti, Observium, or Graphite) derives interface bandwidth graphs from these same byte-counters (i.e. ifHCInOctets / ifHCOutOctets ). What I want to get is the Bandwidth measurement on some vlan.
When to use 64-bit counters in ifxtable?
The ifXTable provides similar 64-bit counters, also called high capacity (HC) counters: ifHCInOctets ( registered customers only) / ifHCOutOctets ( registered customers only) , and ifHCInUcastPkts ( registered customers only) / ifHCOutUcastPkts ( registered customers only) . Q. When should 64-bit counters be used?
Are there 64 bit counters for Cisco IOS?
Note: Cisco IOS Software does not support 64-bit counters for interface speeds of less than 20 Mbps. This means that 64-bit counters are not supported on 10 Mb Ethernet ports. Only 100 Mb Fast-Ethernet and other high speed ports support 64-bit counters.