How do you setting dual WAN pfSense?

How do you setting dual WAN pfSense?

Configuration

1. Step 1: Configure pfsense LAN interface.
2. Step 2: Configure pfsense wan01 interface (ADSL ISP #1)
3. Step 3: Configure pfsense wan02 interface (ADSL ISP #2)
4. Step 4: Confirm both gateways are online.
5. Step 5: Configure monitor IP for each gateway.
6. Step 6: Configuring dual WAN link load balancer.

How do I monitor network traffic in pfSense?

With pfSense® software, there are several methods for monitoring bandwidth usage, with different levels of granularity.

1. pftop.
2. iftop.
3. trafshow.
4. Built-in Graphs.
5. BandwidthD.
6. Darkstat.
7. ntopng.
8. Monitoring on Multiple Interfaces.

What is a bridge pfSense?

A bridge interface device can be created using pfSense. A bridge interface creates a logical link between two or more Ethernet interfaces or encapsulation interfaces. This link between the interfaces selectively forwards frames from each interface on the bridge to every other interface on the bridge.

Can I use pfSense as a switch?

Yes, just create VLANS on the LAN side of PfSense – dont forget to enable those VLANs on the switch or trunk the LAN port with all VLANs and specify VLANs on the switch ports. As you are about to use a pfSense, a router in and of itself, you don’t strictly need a Layer-3 switch.

How to configure pfSense as a router for two internal LAN?

The default gateway is my Netgate device to go to the internet (10.0.0.1) And look at the gateway… its 10.0.0.1 not 10.0.0.4 which is what you have pfsense lan IP set to.. How do you expect to get to the 10.0.1 network on pfsense if you point it towards your internet router?

What happens if you don’t point to pfSense as a gateway?

If you don’t point back to pfsense as the gateway, the machine can not answer.. If the mask is wrong on the client then it would never even send back an answer to pfsense to get sent to the client sending the ping because it thinks that is on its own network, etc.

How did pfSense change from Wan to lab?

So when pfSense first configured the LAN interface was WAN so I renamed it and added a rule to allow traffic through. The LAB interface was the LAN interface, so I renamed that too.

Is the pfSense VM hosted on fluorine?

pfSense is a Hyper-V VM also hosted on fluorine with two vSwitches one is LAN and connected to the physical NIC and the other is a vSwitch connected to LAB. Machine 10.0.0.3 is a physical Windows 10 box.