What does clear interface command do?

What does clear interface command do?

Clear Interface resets the hardware logic on the specific interface. It basically resets the controller. If you were looking to clear the configs on a port, default interface will do the job for you.

How do you clear a Cisco command?

1. To clear AVC NBAR statistics, use the clear avc nbar command.
2. To clear 802.11 radio statistics, use the clear counters command.
3. To clear the statistics of Cisco TrustSec Security, use the clear cts command.
4. To clear the datapath counters or drops, use the clear datapath command.

How do I clear my interface configuration?

In V200R001C00 and later versions, you can run the clear configuration interface GigabitEthernet 1/0/2 command in the system view to clear all interface configurations. However, this command will shut down the interface. To enable the interface, run the undo shutdown command in the interface view.

How do I clear the screen in Cisco command line?

Putty. If using Putty you can right click on the toolbar and select Reset Terminal, this will clear the whole screen until you hit enter and your cli prompt will come back.

What are some valid clear commands?

Answer: Clear Contents, Clear All and Clear Formats are the correct answers.

How do I set default interface?

The default interface command initializes the settings for a particular interface. To delete a setting, enter “no” for the setting command you want to delete. However, there are a lot of settings in the interface, and when you want to delete all of them, it takes a lot of time to delete them one by one with “no”.

How do I reset my Cisco interface?

Reset Cisco switch port/interface to default then apply vlan

1. Switch> en.
2. Switch# conf t.
3. Switch(config)# default interface Gi1/0/1.
4. Switch(config)# exit.

How do I turn off Vty lines?

You can use the clear line command to clear any line on the system (vty or console). Using this command terminates any service, such as an FTP session, on this line and closes any open files. You can specify the absolute number to clear any line.