Contents
Why is RRAS VPN not routing traffic to network?
(We have to use static ip range as also have the 2019 issue of it not working for DHCP relay).
How to establish routing between two site to site VPN tunnels?
I am trying to establish routing between two Site to Site vpn tunnels, both of which are terminating on the same outside interface of my Cisco ASA. Please find attached Network Diagram for the same. All Firewalls used are Cisco ASA 5520. Both VPN tunnels between Point A and Point B, Point B and Point C too are up.
How to route Sitea to SiTec VPN traffic?
NAT0 = Is the ACL that is to be used in the NAT0 rules that will exempt SiteA to SiteC traffic from NAT L2L-VPN-CRYPTO-SITEB = Is the ACL in the L2L-VPN configurations that defines that the traffic from SiteA LAN to SiteC LAN should use the existing L2L-VPN towards SiteB
Why does my SonicWall keep redirecting to a VPN?
Click Configure at the bottom of the page. In this case, while pinging from LAN side of SonicWall to the remote gateway, the SonicWall is generating an ICMP redirect packet. So it looks like a routing issue rather than a site to site VPN one. Then on SonicWall firewall GUI navigate to Manage | Network | Routing, and check the route policies.
Do you need a VLAN for a Raspberry Pi?
If you don’t need a real vlan you can assign additional addresses like this with colon instead of dot. This way you simply have multiple addresses with one interface regardless if the main interface is configured via DHCP or not. You should be able to ping each address easily without any router involved.
How to make a network on a Raspberry Pi?
I would like to have a network for 10+ Pi with a switch (192.168.42.x). This switch is connected to Internet via one port (to an another switch). I try to have one Pi with the ip (eth0) 192.168.1.127 (which is connected to internet) and a virtual ip like 192.168.42.1 to connect to the other Pi (and they will have Internet via Pi #1)
Can a Raspberry Pi interface be connected to two subnets?
An interface cannot be connected to two subnets, except with vlans. You tried this with an additional ip address on the interface. A second ip address can only be set from the same subnet the interface is connected to, in your case either from 192.168.1.0/24 or from 192.168.42.0/24.