What is the benefit of a Layer 3 switch?
Benefits of a layer 3 switch Simplify security management. Reduce broadcast traffic volumes. Ease the configuration process for VLANs, as a separate router isn’t required between each VLAN. Separate routing tables, and as a result, segregate traffic better.
How do you reset a Packet Tracer switch?
Resetting the Cisco IP switch to factory defaults
- Erase the existing configuration: write erase.
- Reload the switch software: reload. The system reboots and enters the configuration wizard.
- In the configuration wizard, enter the basic switch settings:
- When prompted, enter the user name and password to log in to the switch.
How to configure a layer 3 switch?
On the Layer 3 switch, the trunking interface needs to be encapsulated with the dot1q protocol, however it is not necessary to specify VLAN numbers as it is when working with a router and subinterfaces. a. On MLS, configure interface g0/1. b. Make the interface a static trunk port. c. Specify the native VLAN as 99. d.
How are IP phones set up in Packet Tracer?
The IP phones in Packet Tracer are set up like your standard Cisco IP phone in the real world – RJ-45 ports for both switch and PC connections at the back. I’m assuming there’s an internal 3-port switch, but I can’t actually make any configs on the switch from within Packet Tracer itself. Sorry for the confusion: I can’t ping from PC to printer.
How to configure trunking on MLS layer 3 switch?
Step 3: Configure Trunking on MLS. Trunk configuration differs slightly on a Layer 3 switch. On the Layer 3 switch, the trunking interface needs to be encapsulated with the dot1q protocol, however it is not necessary to specify VLAN numbers as it is when working with a router and subinterfaces.
Why does my router drop frame on Packet Tracer?
The router receives the frame, but drops it because it expect VLAN 70 to be native (untagged), because you have configured the router’s VLAN70 interface to be the native vlan. Just tested this is packet tracer, can reproduced the issue and adding the native vlan to the trunk worked. Hope that helps! 11-26-2017 09:56 PM 11-26-2017 09:56 PM