How do I access SonicWall firewall remotely?
The SonicWall can be administered remotely using an existing VPN connection on HTTPS or HTTP. If you already have a running VPN connection to the firewall from behind another SonicWall or from the VPN client, simply log into the unit using its LAN IP address (as you would if located on the LAN segment).
What is preempt mode SonicWall?
Select Enable Preempt Mode to configure the primary SonicWALL appliance to take over from the backup SonicWALL appliance when it becomes available. Otherwise, the backup SonicWALL appliance remains active. During a failover, the backup unit uses the same virtual IP address that was used by the primary unit.
How do I register my SonicWall HA unit?
On the My Product – Associated Products page, in the text boxes under Associate New Products, type the serial number and the friendly name of the new appliance that you want to register as the associated unit. Click Register.
Can a SonicWall be used as a router?
SonicWall is a firewall with routing capabilities (henceforth referred to as the firewall). An ISP modem is a router with some firewall capability. One can set up an ISP modem either as a “Router” or in Bridged Mode (Fig. 1).
What are SonicWall access rules?
Access rules are network management tools that allow you to define ingress and egress access policy, configure user authentication, and enable remote management of the SonicWall security appliance. The POLICY | Rules and Policies > Access Rules page provides a sortable access rule management interface.
Which is the high availability unit on SonicWall?
The box it comes in says “High Availability” but once you get it racked they are identical so sometimes hard to keep track of. So, make sure you start with the actual Primary unit, the one that is not the High Availability unit, and label them as such. Note that when you register the units in MySonicWall.com it will show you which is the “HA” unit.
How to set up a backup SonicWall account?
2. Register the Backup unit in the same MySonicWall account as the Primary then link the Backup unit to the Primary so it can inherit the Primary unit’s licensing for the Primary unit’s MySonicWall page. 3.
Where do I find the ha interface in SonicWall?
3. On larger firewalls (i.e. generally NSA 5600 and above) use two interfaces for HA: one for the HA Control and one for the HA Data for Stateful Synchronization. This is found in the UI at: Manage | High Availability | Base Setup | HA Interfaces tab.
Do you need monitoring IPS for SonicWall?
You must add “Monitoring” (management) IPs to x0. These “monitoring” IPs are required on at least x0 so that the idle unit has an IP and therefore a path to the Internet via the Active unit to get signature updates, talk to MySonicWall (license manager), etc. Go to Manage | High Availability | Monitoring to do this.