What are the requirements for configuring EtherChannel between two switches?

What are the requirements for configuring EtherChannel between two switches?

What are two requirements to be able to configure an EtherChannel between two switches? (Choose two.)

• The interfaces that are involved need to be contiguous on the switch.
• All the interfaces need to work at the same speed.
• All the interfaces need to be working in the same duplex mode.

Can bonded ports be on two different network Ethernet switches?

LACP itself doesn’t provide the ability to bond across multiple switches; it bonds across multiple ports on a single ethernet switch, and depending on the vendor there might even be restrictions on which ports on a switch can be bonded together.

Are two requirements to be able to configure an EtherChannel between two switches choose two?

Why use an Ethernet port on a bond?

You can combine the Ethernet ports on a Linux server together to appear as a single port with one IP address. Combining the Ethernet ports together is called link aggregation or bonding, this page will refer to it as bonding. The advantage is that it increases the bandwidth to your server.

Why is my EtherChannel layer 2 instead of Layer 3?

If you forget to run the no switchport command on an interface, your etherchannel will be layer 2 instead of layer 3! Having said that, let’s configure our switches: Above you can see that our port-channel 12 interface is layer 3 and it’s operational.

What do I need to know about L3 EtherChannel?

Today’s lab focuses on the L3 EtherChannel, but also gives you a chance to configure the rest of the features in the initial list as well. In this lab, you will add configuration to distribution switches Dist1 and Dist2. These two layer 3 switches will route packets for several subnets.

How does an EtherChannel work on a Cisco switch?

An EtherChannel is a Link Aggregation technology whereby two switches are connected together with multiple interfaces which are bundled together to form a single logical interface (“Port-Channel”) therefore increasing bandwidth between the switches.

How to configure layer 2 etherchannels in Cisco Catalyst 3850?

Configuring Layer 2 EtherChannels Step 1. Enters global configuration mode. Step 2. Switch (config)# interface gigabitethernet2/0/1 Specifies a physical port, and enters interface configuration… Step 3. Assigns all ports as static-access ports in the same VLAN, or configure them as trunks. If you