What is the right way to make MPD use PulseAudio?

What is the right way to make MPD use PulseAudio?

What is the right way to make MPD use Pulseaudio (or do whatever is necessary to connect it to other speakers than the default?) Unlike MPD in system wide mode PulseAudio is running in userspace. This means, all pulseaudio settings including Bluetooth discovery and providing a Bluetooth audio sink is done from a user session.

Is there a problem with PulseAudio in Linux?

The audio config always flickers and the sound always stutters [H] = The distro has that problem, but only when an HDMI monitor is connected. The audio doesn’t stutter but the configuration flickers. Distros Ubuntu 19.04 = [?] Manjaro (early 2019) = [?] Elementary OS = [?] Arch Linux (late 2019) = [?]

Where is the bar on a PulseAudio headset?

Below the audio dispositive, there is a bar that shows the intensity of the sound. In the microphone section (the headset has a microphone) the bar changes according to the level of sound it is receiving. However, the output section doesn’t show any change.

Is there a problem with PulseAudio in Windows 10?

I didn’t have any problems with older distributions, the only thing that happened was that in any sound settings, the sound icon or volume would flicker visually, but never affected practically. Now, every distro has flickery settings and the audio is choppy and stutters.

Is there a way to fix PulseAudio on demand?

Solutions: To remedy cause 1, add user mpd to the pulseaudio groups so that mpd can even start pulseaudio on demand: To further fix cause 2, open your X11 session to mpd either by or get rid of the X11-bell-plugin.

How do I start PulseAudio on my computer?

You can also start PulseAudio by running pulseaudio.exe –high-priority to set the default priority to “High”. You can check that your copy of MPD includes PulseAudio support by running mpd –version and making sure “pulse” is in the list of supported outputs.

Why is PulseAudio not connecting to the server?

Feb 15 21:45 : Cannot connect to server in PulseAudio output “pulseaudio” (attempt 1): Connection refused In this case, your problems are twofold: You are running mpd as user mpd which has no rights to access pulseaudio as you, the interactive user, have.