Contents
How much current can you draw from a GPIO?
RPi GPIO input voltage and output current limitations. So, if you have set the current capability to 2 mA, do not draw more than 2 mA from the pin. Never demand that any output pin source or sink more than 16 mA. Current sourced by the outputs is drawn from the 3.3 V supply, which can supply only 50 mA maximum.
Are there any limitations to the RPI GPIO?
RPi GPIO input voltage and output current limitations. Do not drive capacitive loads. Do not place a capacitive load directly across the pin. Limit current into any capacitive load to a maximum transient current of 16 mA. For example, if you use a low pass filter on an output pin, you must provide a series resistance of at least 3.3V/16mA = 200 Ω.
What are the specifications of the GPIO block?
These properties are set for the GPIO block as a whole, not on a pin-by-pin basis. Source/sink current capability does not limit the current into or out of the pin, but only specifies the maximum current for which the output signal high/low voltage specifications will be met.
What can you do with GPIO pins on Raspberry Pi?
The Raspberry Pi’s GPIO pins are quite versatile, and you can modify many of their characteristics from software. You can turn on/off input pin hysteresis, limit output slew rate, and control source and sink current drive capability from 2 mA to 16 mA in 2 mA increments.
What happens when a circuit draws too much power?
If your circuit attempts to draw too much power the power supply will give an error indication and prevent excessive current from flowing.
What’s the maximum current a Raspberry Pi can draw?
Power sources SHOULD provide 5±0.25V and often list a current rating. This is the MAXIMUM current that can be safely drawn without causing the output to drop below its rated voltage. (Of course, very many supplies do not actually meet their published ratings, including many sold by Pi retailers.
What happens to the power supply on a Raspberry Pi?
On all models of Raspberry Pi since the Raspberry Pi B+ (2014) except the Zero range, there is low-voltage detection circuitry that will detect if the supply voltage drops below 4.63V (+/- 5%). This will result in a warning icon being displayed on all attached displays and an entry being added to the kernel log.