Contents
Can a GPIO pin connect to a 5V pin?
Never connect a pin directly to another pin. This can potentially overload and destroy pins. For instance, the GPIO pins are only 3V3-tolerant so connecting directly to a 5V pin would overload them.
Where does the GPIO go on a Raspberry Pi?
Left (GND) comes to pin 6 of the Pi (GND), the right pin (VCC) comes to 3V3 (pin 1) of the Pis. Depending on how many of the relays you want to control, you need to connect a corresponding number of GPIOs to the IN pins.
Where is the 3v3 pin on a Raspberry Pi?
If you connected the 3V3 pin to the cathode instead, the current would be stopped and the LED wouldn’t light up. Take one of your FF (female-to-female) jumper cables and attach it from the anode of the LED to the first 3V3 pin on your Pi, as pictured here:
Do You need A GPIO port expander for the Pi?
To avoid wasting too many GPIOs on the Pi it pays off to purchase a GPIO port expander with more than 4 channels. The structure is very simple since all pins are labelled. Left (GND) comes to pin 6 of the Pi (GND), the right pin (VCC) comes to 3V3 (pin 1) of the Pis.
Why are the GPIO pins on my Raspberry Pi bad?
This is because moters create a phenomenom called a back EMF when turned off which results in a sudden voltage spike. This increase in voltage can overload and damage connected pins. After digging through message boards and articles about this topic, it seems that static electricity can damage your Raspberry Pi, but it is an unlikely occurrence.
How are power supply pins used on Raspberry Pi?
When using one of the power supply pins, you need to eventually connect back to one of the ground pins to complete your circuit or there will be no current. Lastly, there are two EEPROM pins which are specifically used by HATS and not something you need to worry about using directly yourself.
How are the ground pins on Raspberry Pi connected?
Connect to a ground pin To complete the circuit, connect a jumper cable to the resistor and one of the ground pins. All of the ground pins are connected, so they all function the same. There are multiple ground pins mainly for convenience