How do I setup my Raspberry Pi as a NAS?
How to use your Raspberry Pi as a NAS box
- Step 1: Download OpenMediaVault.
- Step 2: Extract the disk image.
- Step 3: Write the OpenMediaVault disk image to your microSD card.
- Step 3: Connect everything and boot up your Pi.
- Step 4: Set up OpenMediaVault.
- Step 5: Mount your disks.
- Step 6: Create shared folders.
What hardware do I need for a NAS?
A power supply between 300 to 400 W should be sufficient for a NAS server. If it is not, then it’s likely that the components have too substantial of a power draw and should be reconsidered. Storage. For a NAS server, you’re going to need a 16 GB flash drive and hard drives for your NAS data storage.
How much RAM do I need for DIY NAS?
You shouldn’t require more than 8GB of RAM on a NAS. You shouldn’t need more than 4GB, but this module from Corsair is reliable and affordable.
How to set up a Raspberry Pi as a NAS?
Tutorial: how to set up Raspberry Pi as NAS? Step 1: download and install OpenMediaVault; Step 2: start the Raspberry Pi NAS and change the keyboard layout; Step 3: change password and display IP address; Step 4: logging onto the web interface; Step 5: securing the web interface; Step 6: connecting the storage media to the Raspberry Pi NAS
What does a network attached storage ( NAS ) mean?
A NAS or network attached storage, is the best way to keep your data backed up and stream and access content from all the devices connected to the network. But a NAS is really a computer that is connected to the network and computers can draw a large amount of current, especially as it is powered on all the time.
What is the IP address on a Raspberry Pi?
The IP address (“inet addr”) listed under “eth0” is particularly important to further configure your Raspberry Pi NAS server. This is the address assigned by your router to the NAS server.
How can I connect my Raspberry Pi to my Network?
Connect the Raspberry Pi to a screen using an HDMI cable. Connect the Raspberry Pi to your network using an ethernet cable. Power up the system by connecting the power cable to the Raspberry Pi. You’ll see the automatic starting procedure on the sceen. Wait until you see the same message as shown in the last picture in this step.