Contents
What happens when promiscuous mode is enabled?
In promiscuous mode, a network device, such as an adapter on a host system, can intercept and read in its entirety each network packet that arrives. This means the adapter does not filter packets. Instead, it passes each packet on to the operating system (OS) or any monitoring application installed on the network.
How do I set eth0 promiscuous mode?
Instructions
- To enable the promiscuous mode on the physical NIC, run the following command on the XenServer text console: # ifconfig eth0 promisc.
- Run the ifconfig command and notice the outcome: eth0 Link encap:Ethernet HWaddr 00:1D:09:08:94:8A. inet6 addr: fe80::21d:9ff:fe08:948a/64 Scope:Link.
How do I turn off promiscuous mode?
Disable Promiscuous Mode
- To disable promiscuous mode on the physical NIC, run the following command on the XenServer text console: # ifconfig eth0 –promisc.
- Run the ifconfig command again and notice that promiscuous mode is now disabled.
Is promiscuous mode monitor mode?
Unlike promiscuous mode, which is also used for packet sniffing, monitor mode allows packets to be captured without having to associate with an access point or ad hoc network first. Monitor mode only applies to wireless networks, while promiscuous mode can be used on both wired and wireless networks.
What happens when a network interface is put into promiscuous mode?
When a network interface is placed into promiscuous mode, all packets are sent to the kernel for processing, including packets not destined for the MAC address of the network interface card.
How does a sniffer detect a promiscuous node?
To achieve this, all sniffers must set the Network Interface Card (NIC) of their PC’s into a mode called “promiscuous mode”. Then the NIC will blindly receive all packets and pass them to the system kernel. The Address Resolution Protocol (ARP) request packets are used to query hardware addresses from IP addresses.
Why is promiscuous mode a bad thing on Linux?
The one main reason that this is a bad thing is because users on the system with a promiscuous mode network interface can now use a tool like a sniffer to view any and all network packets. Let’s look at how to detect an interface going into promiscuous mode on Linux:
Can a host integrity monitoring system detect a promiscuous interface?
Although network security monitoring can detect a promiscuous interface, it is also something that a host integrity monitoring system can easily detect. Most UNIX systems reveal promiscuous status in the interface viewed with the ifconfig command. For example, on FreeBSD: