How to customise the label in align environment?

How to customise the label in align environment?

I’d like to slightly customise the label in the align environment. The need arises when I have two equations on the same line, and I would like to label them (1a,b) or similar. The example below works as expect when I use the equation environment, in that it labels the equations (1a,b) and (2a,b) which is what I want.

Can you put all equations into one alignat environment?

With a trick you can put all equations into one align (or alignat) and subequations environment and still have different labels. And this trick is to explicitly set a ag for the last equation that replaces the automatic numbering.

What does the environment align mean in latex?

@jvriesem: the environment align is meant for multiple equations. Each equation will receive a number. If you use an equation environment, and put an aligned environment inside it, the whole block is considered as one equation, and will receive one number.

Is the \\ label on the same line as onumber?

The \\label is on the same equation line (not code line) as the onumber and therefore doesn’t get any equation number to label and to reference later. You need to move onumber (or the \\label) before the \\\\: In the above case the equation number is placed in the second row.

How to align vertically a label and input?

The accepted solution requires you treat the div as a table cell. This should work perfectly, cross-browser. Cheers! Use padding on the div ( top and bottom) and vertical-align:middle on the label and input. Wrap the label and input in another div with a defined height.

How do you align labels in Microsoft Word?

Below are instructions for doing so in Maestro Label Designer and Microsoft Word. Hover over “File” and then “Print” in the blue navigation bar to access the Alignment Wizard. Click “Create Alignment Page,” load a blank label sheet into your printer, and print the document that opens.

How do you adjust the margins on a label?

Try printing your labels again. You can also manually adjust your margins by clicking on “Page Setup” in the same “File,” “Print” menu. Read the steps below under Microsoft Word for additional instructions. Grab a ruler and determine how far your design is off in each direction on your printed sheet.

What’s the best way to align a Dymo label?

Getting it right with a label that is only 1/2″ wide can be frustrating. The easiest solution would be to shrink the size of your barcode so that it does not even come close to your Dymo’s ambiguous page margins. I’ve had limited success by fooling the Dymo into thinking that I’m using a different label roll than the one I am actually using.