Contents
Share an external USB drive via Samba on your Raspberry Pi
- sudo fdisk -l.
- sudo mkdir /media/USBHDD sudo mkdir /media/USBHDD/share.
- sudo chmod -R 777 /media/USBHDD/share.
- sudo mount -t auto /dev/sda1 /media/USBHDD.
- sudo apt-get install samba samba-common-bin.
- sudo cp /etc/samba/smb.conf /etc/samba/smb.conf.old.
Can I use an external hard drive as a flash drive?
You asked if you could you use one of your memory sticks as “a normal day-to-day drive.” The answer is yes, but it’s not particularly simple, and I don’t recommend it. USB flash drives are marked as being removable, which means the operating system treats them differently from local hard drives.
Which is better flash drive or external HDD?
In general, the performance of external hard drives is better than that of flash drives. If comparing external HDDs and flash drives, as normal, external hard drives are much faster in bulk data transfer while USB flash drives may be faster when transferring small bits of data.
What is the difference between a USB flash drive and an external hard drive?
A USB flash drive is a data storage device that includes flash memory with an integrated USB interface, and it’s also called a pen drive and thumb drive. An external hard drive is a hard disk storage product that emphasizes portability and realizes large-capacity data exchange between computers.
Today it is time to use Samba for USB Drives sharing. 1. Create new directory where your drive will be mounted 2. List your storage devices and save UUID of your drive (Update) more readable command:
Where to find external USB drive on Raspberry Pi?
Now, look towards the bottom and assuming this is the only additional drive you have plugged in, you should see something like this: /dev/sda1 is the name of the partition on our external drive. Next we’re going to create a directory within our /media/ folder to mount our drive into, and also a sub-directory within it.
At this point you should be able to read and write to your Samba share via Finder by clicking on retropie under the Shared heading and then accessing your new folder called share. The final step we’ll want to do is edit our fstab configuration so that our drive will properly mount whenever our Raspberry Pi reboots.
How do I mount a USB hard drive in Luci?
Now go to the Mount points tab under System in the Luci web-interface. You will find your USB storage device listed already as show below. If you have formatted your drive with the Ext file system, all you need is to tick Enable and then Save & Apply.