Contents
Why do I keep getting segfaults in Bash?
As noted in the last example above, some segfault problems are not due to bugs in your program, but are caused instead by system memory limits being set too low. Usually it is the limit on stack size that causes this kind of problem. To check memory limits, use the ulimit command in bash or ksh, or the limit command in csh or tcsh.
Why does Wget stop working with error segmentation fault?
Suddenly (at least) wget stopped working with error Segmentation fault. It’s not even trying to do something. So after some googling I’ve installed gdb and tried to debug wget:
Where does the segfault occur in the code?
Where the segfault occurs is generally only a clue as to where “the mistake which causes” it is in the code. The given location is not necessarily where the problem resides.
How to find which thread caused segfault in a post?
In my application I handle SIGSEG to produce a backtrace and call abort () to generate a core dump. If I now run a gdb-post-mortem analysis of the core, the thread which caused the SEGFAULT is no longer visible. Is there anything I can do so I see the cause for the SEGFAULT?
What causes a program to crash with a segmentation fault?
Overview A segmentation fault (aka segfault) is a common condition that causes programs to crash; they are often associated with a file named core. Segfaults are caused by a program trying to read or write an illegal memory location.
How to debug a segmentation fault in C-Quora?
Start your debugger with the command gdb core, and then use the backtrace command to see where the program was when it crashed. This simple trick will allow you to focus on that part of the code.
When to put a trap on the end of a script?
If you run your script under set -e, you can put a trap on EXIT (or 0 ). It will be executed when your script terminates (whether due to a command returning a nonzero status, or by explicitly calling exit or by falling off the end of the script).