What kind of snapshots do you use in Snapper?
Btrfs, a new copy-on-write file system for Linux, supports file system snapshots (a copy of the state of a subvolume at a certain point of time) of subvolumes (one or more separately mountable file systems within each physical partition). Snapper lets you manage these snapshots. Snapper comes with a command line and a YaST interface.
How to restore files from an hourly snapshot?
Hourly backup snapshots are of the type Single and are marked with the description timeline. To restore files from these snapshots proceed as described in Procedure 4.1, “Undoing changes using the YaST Snapper module” or Procedure 4.2, “Undoing changes using the snapper command” .
How are snapshots created in zypper and YaST?
For this purpose, Snapper is configured to create a pair of snapshots before and after each run of zypper and YaST. Snapper also lets you restore system files that have been accidentally deleted or modified. Hourly backups are created for this purpose.
How often are snapshots created in Snapper-SUSE?
A single snapshot is created every hour. Old snapshots are automatically deleted. By default, the first snapshot of the last ten days, months, and years are kept. Timeline snapshots are disabled by default.
When to enable or disable snapshot in Snapper-SUSE?
Taking snapshots is automatically enabled if the root partition ( /) is big enough (more than approximately 16 GB). By default, snapshots are disabled on partitions other than / . If you disabled Snapper during the installation, you can enable it at any time later.
Which is the default snapshot config for snapper?
The default config installed with Snapper for the / directory is named root. It creates and manages the YaST and Zypper snapshots as well as the hourly backup snapshot for / . You may create your own configurations for other partitions formatted with Btrfs or existing subvolumes on a Btrfs partition.