How do I delete a route in Cisco IPv6?

How do I delete a route in Cisco IPv6?

Remove IPv6 Addresses From an Interface

1. Enter Interface Configuration mode for the VLAN 1 interface. SEFOS# configure terminal SEFOS(config)# interface vlan 1.
2. Delete the IPv6 address configured for that interface.
3. Review the IPv6 information for the VLAN 1 interface.

How do I remove IPv6 address from router?

To remove an IPv6 address from an interface, use the no ipv6 address ipv6-prefix/prefix length eui-64, no ipv6 address ipv6-address link-local, or no ip address enable interface configuration command.

What is the default route for IPv6?

The default route in IPv4 is designated as 0.0. 0.0/0 or simply 0/0. Similarly, in IPv6, the default route is specified as ::/0. The subnet mask /0 specifies all networks, and is the shortest match possible.

How do I turn off IPv6 in Windows 10?

IPv6: How To Disable

1. Use the shortcut, Windows Key + X to open the Control Panel.
2. Open Network and Internet.
3. Open Network and Sharing Center.
4. Click Change Adapter Settings.
5. Right-click your connection and go to Properties.
6. Uncheck the box next to Internet Protocol Version 6 (TCP/IPv6) to disable it.

Should I disable IPv6 Windows 10?

We do not recommend that you disable IPv6 or its components. If you do, some Windows components may not function. We recommend using Prefer IPv4 over IPv6 in prefix policies instead of disabling IPV6.

How do I get rid of default GW?

Delete your current default gateway. Delete your existing default gateway if you intend to change it. Type sudo route delete default gw IP Address Adapter . For example, to delete the default gateway 10.0. 2.2 on the eth0 adapter, type sudo route delete default gw 10.0.

How to delete IPv6 Rip routes in Cisco?

When the name argument is specified, only routes for the specified IPv6 RIP process are deleted from the IPv6 RIP routing table. If no name argument is specified, all IPv6 RIP routes are deleted. Use the show ipv6 rip command to display IPv6 RIP routes.

How to remove an IPv6 address from an interface?

Review the IPv6 information for the VLAN 1interface. SEFOS# show ipv6 interface vlan 1  vlan1 is up, line protocol is up IPv6 is Enabled Link local address: fe80::214:4fff:fe6c:560f The link-local address is auto-configured when you remove a link-local address in the IPv6 interface.

How to delete IPv6 neighbors in privileged mode?

To delete all entries in the IPv6 neighbor discovery cache, except static entries and ND cache entries on non-virtual routing and forwarding (VRF) interfaces, use the clear ipv6 neighbors command in privileged EXEC mode. clear ipv6 neighbors [ interface type number [ ipv6 ipv6-address] | statistics | vrf table-name [ ipv6-address | statistics ]]

How to delete a route in Windows Vista?

This is the default. Remarks: Deletes an IPv6 route. Example: delete route 3ffe:: /16 “Internet” fe80:: 1 Deletes a route. / Windows Vista Displays Information. Shows neighbor cache entries.