Contents
How do I set a static route to default?
Configuring a default static route
- Enter global configuration mode. device# configure terminal.
- Enter 0.0. 0.0 0.0.
- (Optional) Enable the default network route for static route next-hop resolution.
- (Optional) Configure next-hop recursive lookup to resolve the next-hop gateway.
When should we use a default static route?
A default route defines where packets will be sent if no specific route for the destination network is listed in the routing table. If no default route is set, the router will discard all packets with destination addresses not found its routing table. Consider the following example: We have a network of three routers.
Which of the following items are included in static routes?
The static route consists of a destination network address or host, a corresponding network mask, and the IP address of the next-hop IP address. The null route consists of the destination network address or host, a corresponding network mask, and either the reject or blackhole keyword.
How to configure RIP v2 example router?
* Configuring RIP v2 on a Network. * Redistributing Static Routes into RIP. * Creating a Default Route in RIPv2. * Disabling RIP on an Interface. From the configuration above, the router rip command activates the protocol, version 2 defines the RIP version in use and the networks directly connected to the router HQ network were all declared.
What is redistribute static command in RIPv2?
The redistribute static command tells RIP to forward static routes in addition to the directly connected routes and the routes that have been learned from other RIP routers, which it forwards by default: HQ (config)#ip route 192.168.2.0 255.255.255.0 172.16.1.2
Which is the default route in Rip R1?
To reach the Internet, R1, R2, and R3 should have a default route. There are two ways how we can configure this: We could configure a static default route on R1, R2 and R3. We could configure a static default route on R1 and advertise it in RIP to R2 and R3. I’ll show you how to configure option 2.
How to get Rip to propagate a default route?
One of the two ways to get RIP to propagate a default route is to use the default-information originate command. Another method is using redistribute static; you will accomplish the same thing: You want to prevent an interface from participating in RIP.