What does Bash support do in Vim editor?
bash-support is a highly-customizable vim plug-in, which allows you to insert: file headers, complete statements, comments, functions, and code snippets. It also enables you to perform syntax checking, make a script executable, start a debugger simply with a keystroke; do all this without closing the editor.
Where do I find my command line in Vim?
Your command appears down the bottom of the terminal. Commands in vim start with a colon. w means write, as in write the file to disk (save it), and q means quit. So we just gave the command, “save this file then exit”. Now we’re outside vim and can run the bash script to see how it works.
How do I leave insert mode in Vim?
To leave insert mode, press the Escape key. Now we are back in command mode – there’s no “– INSERT – at the bottom anymore. To save and quit, type and enter :wq`. Your command appears down the bottom of the terminal. Commands in vim start with a colon. w means write, as in write the file to disk (save it), and q means quit.
How to write your own code in Vim?
It is possible to write your own code snippets under ~/.vim/bash-support/codesnippets/. Importantly, you can also create your own code snippets from normal script code: choose the section of code that you want to use as a code snippet, then press w, and closely give it a filename.
Why does VIM not respond to writevt command?
No other key sequence or mouse event can stop vim. And no command I am sending to vim or to the shell bash by “writevt” has an effect. At least vim should be responsible to a SIGNAL, e.g. USR1. But Vim does not react. In addition it is bad that vim does not show in any way that vim is busy and that it is e.g. searching.
Is there a way to stop VIM from running?
CTRL-C does not work. No other key sequence or mouse event can stop vim. And no command I am sending to vim or to the shell bash by “writevt” has an effect. At least vim should be responsible to a SIGNAL, e.g. USR1.