Contents
Why landing gears are made retractable for high speed aircraft?
For aircraft, the landing gear supports the craft when it is not flying, allowing it to take off, land, and taxi without damage. Faster aircraft have retractable undercarriages, which fold away during flight to reduce drag.
How many types of landing gear are there?
Landing gear usually comes in three basic wheel arrangements: conventional, tandem and tricycle-type. Beyond this, landing gear is then classified as either fixed or retractable. Fixed landing gear hangs underneath an aircraft during flight, whereas retractable landing gear is stowed inside an aircraft during flight.
What are the different types of landing gear?
Landing gear is the part of an aircraft which allows the aircraft to land and takeoff again. It is the principle support of the airplane when parked, taxiing, taking off, or landing. The most common type of landing gear consists of wheels, but landing gears can also be floats for water operations, or skis for landing on snow.
Why is there a restructuring of landing gear?
“Our landing gear product division is currently undergoing a restructuring programme to adapt to the changes in the MRO market. This is because a landing gear combines hundreds of large and small parts, so the work on those parts requires a process chain with excellent coordination between the parties involved.
What kind of Technology is used for landing gear overhaul?
“Lufthansa Technik has already made significant investment in order to use this technology for landing gear parts as well. “This technology might be new for the landing gear business, with the A380 landing gears being the first where this technology is widely used; however, it is also used in other departments of ours, such as engine overhaul.
How did a nose landing gear get repaired?
A nose landing gear collapsed during a landing of one of the Starship test airplanes; the airplane was flown home, repaired, and was returned to service in 10 days. The repairs were made by procuring blank parts from the factory, cleaning out the damaged areas, and splicing replacement sections into place by bonding and riveting.