Contents
Can we use Thevenin in BJT?
BJT is a non-linear network hence we cannot apply Thevenin’s theorem for it.
How do you find Thevenin resistor?
Find the Thevenin resistance by removing all power sources in the original circuit (voltage sources shorted and current sources open) and calculating total resistance between the open connection points. Draw the Thevenin equivalent circuit, with the Thevenin voltage source in series with the Thevenin resistance.
What is the formula of Thevenin’s resistance?
Any combination of batteries and resistances with two terminals can be replaced by a single voltage source e and a single series resistor r. The value of e is the open circuit voltage at the terminals, and the value of r is e divided by the current with the terminals short circuited.
How do you calculate VBB?
Calculate the base voltage, Vbb, which is the voltage measured at the base of the transistor. Use the formula Vbb = Vcc * [R2/(R1 + R2)]. Using the numbers from the previous examples, the equation works as follows: Vbb = 12 * [15/(25 + 15)] = 12 * (15/40) = 12 * 0.375 = 4.5 volts.
What is dual of Thevenin theorem?
The Norton’s theorem establishes, dually, that any linear circuit seen from one port may be represented by a current source (with a value equal to the short-circuit current) in parallel with an impedance (with the same value as in the Thévenin’s theorem).
What is meant by Thevenin’s theorem?
Thevenin’s theorem states that it is possible to simplify any linear circuit, irrespective of how complex it is, to an equivalent circuit with a single voltage source and a series resistance.
Which one is the BJT configuration?
Bipolar Transistor Configurations Common Base Configuration – has Voltage Gain but no Current Gain. Common Emitter Configuration – has both Current and Voltage Gain. Common Collector Configuration – has Current Gain but no Voltage Gain.
Do you need a base resistor for a BJT?
On the schematics are shown 2 diodes, but that will be expanded to 8 LEDs for each shift register. The base resistors R3 and R4 are doing nothing useful. The circuit would be better with them replaced by wires.
How is the voltage divider biased with Thevenin theorem?
For case 2 (the transistor is not connected) the voltage divider’s midpoint voltage V X is the Thevenin voltage VTH. Because VB’s value is influenced by the I B term and VTH’s value is not, it’s evident that for I B ≠ 0, VB and VTH cannot be equal; they must be different values.
How to choose a bias point for a transistor?
Say I choose a bias point on an I-V characteristic curve at the IC = 16mA. If this transistor has a beta of 200 then that means a IB = 80uA. Lets also say I want 1 volt across the emitter resistor R2. Now lets take the resitive divider biasing scheme and create its thevenin equivalent: VTH is going to be V1* (R3/ (R4+R3) and RTH = R3*R4/ (R3+R4).