Contents
How to use an interrupt in stm32f103c8?
Syntax for Interrupt in STM32 ISR has following syntax attachInterrupt (digitalPinToInterrupt (pin), ISR, mode) in Arduino and the same can also be used in STM32 as we use arduino IDE to upload code. digitalPinToInterrupt (pin): Like in Arduino board Uno we have pins 2,3 & in mega we have 2,3,18,19,20,21 for interrupts.
How to program stm32f103c8 using Keil UVision?
Step 1:- First install all the device drivers for ST-LINK V2, software tools STM32Cube MX & Keil uVision and install necessary packages for STM32F103C8. Step 5:- Now the pin-out sketch of STM32F103C8 appears, here we can set the pin configurations. We can also select our pins in the peripherals section according to our project.
How are GPIO pins used in stm32f103c8?
In STM32F103C8 we also have interrupt pins any GPIO pins can be used for interrupts. We just to specify the input pin that we are using for interrupt. But while using more than one interrupts at the same time we may need to follow some restrictions.
How many channels are there in the STM32 ADC?
The STM32F103C8 (Blue Pill) & STM32F432KC have a 12-bit ADC which is a successive approximation analog-to-digital converter. It has up to 18 multiplexed channels allowing it to measure signals from sixteen external and two internal sources. A/D conversion of the various channels can be performed in single, continuous, scan, or discontinuous mode.
What happens when the reset state of STM32 is reached?
At the reset state, all interrupts are disabled. The processor begins executing the code instructions with a base execution priority lower than the lowest programmable priority level, so any enabled interrupt can pre-empt the processor. When an enabled interrupt is asserted, the interrupt is serviced by the corresponding ISR handler.
How are external interrupts used in microcontrollers?
To get rid of these issues, we’ll need to use external interrupts – a vital feature in every common microcontroller. STM32F1xx series are ARM Cortex M3 based MCUs. The Cortex M3 based MCUs have a sophisticated and yet easy to use interrupt system called the Nested Vectored Interrupt Controller ( NVIC ). It ensures low latency and high performance.
How to use STM32F103 timer interrupt in Keil?
The interrupt is simply used to toggle the LED on our STM32 Board. This tutorial is divided into three steps: Open STM32CubeMX. Click on ‘New Project’. From Series Select ‘STMF1’, from ‘lines’ select STM32F103. From MCUs list, select ‘STM32F103RBTx’.
How to set prescaler for STM32F103 timer interrupt?
Now, in this “Parameter Settings” tab (already selected) under counter settings Select ‘Prescaler (PSC – 16 bits value)’. And in front of that you will see a drop down arrow (at a place indicated by red arrow in following figure), Click on that.