What wires do you need for LED lights?

What wires do you need for LED lights?

Most people would likely recommend using a solid core 18-gauge wire for your LED lights. The cost difference between this wire size and a much smaller cable is negligible, and 18-gauge is about as big as you can go if you would like your wires to fit into most holders or terminals.

Can you run electrical wire behind crown molding?

You should be “legally” fine with running the Romex behind the crown molding as long as you install it per code Article 334, (Proper supports every 4 1/2′, and a support withing 1′ of the box).

How can I hide LED lights in my room?

LED strips are 1⁄16 in (1.6 mm) thick, so they can easily be hidden just about anywhere in your home. You can use LED strips as a light source or for accent lighting, depending on where you place them. Simply cut your strip to length, peel off the backing, and stick the LED strip out of sight.

Do LED lights require special wiring?

LED lights don’t need special wiring. They’ll work with any standard light fixture, as long as it isn’t enclosed, which could cause heat damage. Poor wiring can cause electrical interference, but this is easily solved with a suppressor. Other things to look for when swapping to LED bulbs.

Should I put my LED lights on the wall or ceiling?

We recommend having the lights go up your wall, but if you prefer to start the line of lights from the top of your wall, you will need LED strip clips to help hold up the power supply against the wall.

Should I put LED lights on floor or ceiling?

If you choose to fit horizontally, it’s best to stick the LED as close as possible behind the lip of the drop-ceiling, in order to avoid light-dots shining on the vertical surface behind.

Is El WIRE brighter than LED?

EL wire and tape produces a solid line of light and color, while LED strips have discrete points of light from individual LEDs. LED strips are the clear winner in this category, as they can easily change color and brightness while EL wire and tape can only be one color and level of brightness.

Can I use speaker wire for 12v LED lights?

You can definitely use speaker wire for 12v power. The only factor to consider is the wire gauge. Various gauges will allow for higher or lower amperage, which, when multiplied with volts (in our case 12v), will give you the electrical load (watts) that the electrical device or appliance should be.

What’s the best way to install crown molding lighting?

To provide sufficient space behind and conceal the lights, a 1×2 board is added to the back and the crown is hung upside down. The crown is installed in reverse so the thicker ceiling-edge can hold the weight of the “floating” molding. It also causes the angle to be more obtuse, providing more space behind for the string.

How tall should crown molding be in order to shine?

So that the light from each diode has enough room to blend together seamlessly into a continuous and smooth glow, and for the light to shine up into the ceiling, it’s usually best to install the crown molding a minimum of 7 to 8 inches below the ceiling.

What do I need to put LED light on ceiling?

Before you start, cut enough triangular 2-inch wood wedges to space at 2-foot intervals along your ceiling. You’ll also need chalk, a tape measure and the hardware that came with your lights. A drill, finishing nails and a hammer will get the job done, and you can use wood filler to cover unsightly nail holes.

How often do you need to nail wedges to crown molding?

Nail the 2-inch wedges every 2 feet throughout the room; the bottom of the wedge needs to be flush with your chalk line. Place your crown molding against the wedges and make sure it’s level. Nail it in place and move on to the next until each piece is attached. Once that’s done, mount your lights along the top of your crown molding.